Stuart SBH200D Block Heater with SBHCONC/1 Sample Concentrator

This Genevac miVac Duo Centrifugal Concentrator was removed from a university lab where it was surpl (more)us to requirements. The unit powers up and is in good working order. The unit is in reasonably good cosmetic condition but has a cosmetic crack in the lid and the seal has split.

Savant Speed Vac Model SPD121P Centrifugal Concentrator Evaporator This was removed from a universit (more)y lab where it was surplus to requirements. The unit powers up and is in good working order, though it has not been tested under a vacuum

Genevac miVac Centrifugal Concentrator System Lab This was removed from a university lab where it wa (more)s surplus to requirements. The unit powers up and has been tested with a digital thermometer (not included). We are unable to test the system further at our facility. System includes the following: 1x Genevac miVac Control BoxType: 600037-05S/N: 084655 1x Genevac miVac PumpM/N: QUP-23050-A00S/N: QUP-230090077 1x Genevac miVac SpeedtrapM/N: MST-23050-A00S/N: MST02090324 1x Genevac miVac ConcentratorM/N: DUC-23050-A00S/N: DST02090233 1x Rotor 8x50ml tubesP/N: DRC-50CCT-008 1x Rotor 84x1.5ml tubes (fitted)P/N: DRC-15EPP-084 1x Genevac miVac Pressure Controller Manual

Labconco CentriVap Benchtop Concentrator Eliminates bumping and foaming, maximizes trace solute  (more)recovery Microprocessor-controlled 300w heater covers ambient to 100C in 1° increments Optional Heat Boost™ surrounds chamber with extra controlled heat at programmed temperature, in closer proximity to sample Electrical receptacle included for an accessory vacuum pump (available separately) Vacuum delay prevents bumping by allowing rotor to achieve speed before applying vacuum Quick-Start™ button starts rotor, heater, timers and pump Quick-Stop™ system stops pump, opens vacuum release valve and stops rotor in seconds after time expires or RUN/STOP button is pressed Memory stores nine user programs (temperature/heat time/run time); LCD shows operating parameters and programs Compact, low-profile design Choice of removable acrylic lid with large, durable lid seal, or glass lid for use with solvents that attack acrylics Safety latch locks lid when rotor is turning, prevents start-up when lid is open Corrosion-resistant sample chamber has epoxy finish for easy cleaning and decontamination Microprocessor-controlled brushless motor runs at up to 1725rpm Stacks on top of cold trap to save space With 0.5 in. O.D. vacuum tube fitting INCLUDED: The Labconco 7810010 CentriVap Benchtop Concentrator, 115V, 50/60Hz includes: - Tubing - Clamps x 2 - Coupling Insert - Power Cord - Operator's Guide - Manufacturer's Documentation - 1 Year Manufacturer's Warranty

Labconco Refrigerated CentriVap Benchtop Concentrator with Glass Lid Programming holds two tempe (more)ratures and times Setpoints for first and second temperatures and run times are selected separately PREHEAT/COOL button activates the refrigeration system and heater to reach setpoint temperature Set temperatures and times can be altered while a program is in process Memory stores up to nine user-defined programs Choose removable acrylic lid or solvent-resistant glass lid, each with large phenol-free lid gasket Utilize centrifugal force, vacuum and heat Brushed, stainless steel and glacier white, epoxy-coated steel exterior w/blue accents 300-watt heater increases temperature in one degree increments up to 100C Quick-Start One Button Start Up to simultaneously activate rotor, heater, timers and vacuum pump Brushless motor spins up to 1725rpm Quick-Stop system stops vacuum pump, open valve and stop rotor Automatic vacuum release valve Lid latch with safety sensors Easy-to-read LCD display Separate heat and run times, each from 1 to 999 minutes Audible alarm signals completion of set point run time Electrical receptacle enables connection of accessory vacuum pump Vacuum pump has quick disconnect fitting for connection of a vacuum gauge 12 in. dia. chamber accommodates a wide variety of rotors, including microtiter plate rotors for 96-well plates Click Here to View Product Video INCLUDED: The Labconco 7310021 Refrigerated CentriVap Benchtop Concentrator with Glass Lid, 115V, 50/60Hz includes: - Tubing - Clamps x 2 - Coupling Insert - Power Cord - Operator's Guide - Manufacturer's Documentation - 1 Year Manufacturer's Warranty

Water bath from 25°C to 99.9°C for the laboratory The shaking water baths of the LAUDA Hydro series  (more)stir laboratory samples with linear or orbital motion, depending on the model. They are reliable instruments, ideal for any laboratory application, be it biological, medical or biochemical, guaranteeing a homogeneous distribution of the temperature. The integrated speed controller enables a load-independent, continuously adjustable stirring movement with soft start. The H 20 SW and H 20 SOW shaking water baths are equipped with a cooling coil as standard. The temperature range can be extended to a minimum of +10°C by connecting them to the domestic water supply or commercially available circulating chillers. Qualitative characteristics - Digital regulation of the temperature and indication via LED display - Load-independent, continuously variable stirring with soft start - Electronic monitoring of the thermoregulator functions, with two fuses for under/over temperature protection - Tank, frame, cover with condensation channel, shaking basket and heater in stainless steel - No dripping condensation – arched insulating lid to reduce heat loss and prevent condensation from dripping onto samples Operation All water baths come standard with a perforated pan and no racks are required. Flasks and containers can be placed directly on the bottom. The drain valve is located on the rear side. Controllers The control panel consists of a large, high-contrast TFT display and a membrane keyboard with four softkeys, protected against dirt and water drops. The menu will guide you on how to use the bain-marie correctly. Esempi applicativi - Bacteriological tests - Molecular biology - Demulsivity studies - Processing of chemical reactions - Thawing - Metallurgical analyses - Incubation of microbiological assays - heating reagents - Environmental studies - Food Processing (QC) - Water quality research - Cytochemistry Accessories available Water level regulator. The heating element is located directly under the sieve plate for even temperature distribution in the tank. Electronic monitoring of the temperature regulator. Two independently operating temperature fuses. Improved visual and audible alarms for increased sample safety. Control elements tilted back for increased splash protection and improved operating comfort. - Perforated plate to place the glassware directly on the bottom. - Fill mark max. to prevent overflows. - Easy removal of sieve plate for cleaning. Highest quality materials: tank interior, lid, sieve and heating element made of stainless steel. Heat insulating lid in stainless steel, double walled with internal curvature to guide the condensate. Limescale deposits inside the water bath can be removed with normal commercial descalers. The internal tray can be easily disassembled and lifted for quick and thorough cleaning. Recommended accessories - Water level regulator. Thanks to this accessory, the loss of water inside the instrument (through evaporation) is compensated and the water level is kept constant. Furthermore, it allows use at temperatures below ambient temperatures, with a minimum of approx. 3°C above tap water temperature.

Zoom ratio 8.5:1 Focussing range 50 mm Headpiece 45° inclined, interpupillary distance 50 – 76 mm Di (more)stortion free objective, 1X: N.A. 0.084, W.D. 81 mm Widefield eyepiece, high eyepoint, F.N. 24, diopter lock mechanism, build in double cross line Transparent stage plate Illumination mode: high contrast, low contrast and oblique illumination Illumination area Ø 40 mm

Melles Griot Optical Table Isolator Product No. 070WSS01 This item was removed from a university lab (more)oratory where it was surplus to requirements. The isolator is in good cosmetic condition and is in stable structural condition. The frame includes wheels for easy mobility. Specifications: - Overall Dimensions: L90 x W75 x H74.2 cm - Tabletop Dimensions: 90 x 75 x 6 cm - Distance from Floor to Tabletop: 74 cm - Frame Dimensions: L89 x W74 x H67.5 cm - Measurement Type: Imperial Includes:- Mobile frame with wheels Product No.: 070WSS01Serial No.: 2443

This Heraeus HERAcell 150 CO2 Laboratory Incubator was removed from a university lab where ti was su (more)rplus to requirement. The unit has been professionally serviced and is in good working order. A report is available on request. It is in good cosmetic condition with minor marks.

The newest line of Radwag Mass Comparators enables adjusting mass standards and weights according to (more) the OIML recommendations (R-111) from 1 mg to 200 g for F2 class and lower. The comparators are used both for ensuring traceability of mass measurements, and verification of weights in accordance with the principles of legal metrology. RADWAG Mass Comparators have gained recognition among Accredited Calibration Laboratories in many countries. Mass comparator XA 5Y.KO series comprises two components. One of them holds the electronic module, and the other precise mechanical measuring system. The comparator features an aesthetic, large weighing chamber and a glass draft shield in one. Its asset is an automatic door opening system. The XA 5Y.KO series features an intuitive menu supporting a user in instrument operation.