cmc Instruments NGM11 NGM 11 Stickstoff-Membran-Generator

PEAK Scientific PH600 Precision Hydrogen Generator This was removed from a university lab where it w (more)as surplus to requirements. The unit powers up but we were unable to test it further. It is in good cosmetic condition with marks from use. It is sold for spares/repairs due to the nature of the instrument and that it is untested.

This Peak Scientific Nitrogen Gas Generator Model: NG250A was removed from a university lab where it (more) was surplus to requirements. The unit powers up and has passed a professionally performed health check with a couple of advisories. It did not require a service reset. The full report is available on request. It is in good cosmetic condition with marks from use. It comes with a user manual and disk.

Limpsfield LCNP15 Natural Gas 1305 Kw Burner with Autoflame Control System This item was removed fro (more)m a university where it was surplus to requirement. It is in good cosmetic condition and in good working order. The item details are as follows: Model LCNP15Serial No. 01160Manufactured 30.05.14Output 1303Kw/hr With Autoflame Combustion Management SystemPart Nos. 2 x MM10005, Serial Nos. 12294, 12331 Siemens Ignition Transformer Type ZE 23/8.5 Dungs LGW 50 A4 pressure switch WEG W22 7.5hp 415 volt fan motor Caldaia A Condensazione high limit cut-off control 2.0" gas inlet pipe

SCHMIDLIN DBS PG-H2 Hydrogen Generator, 250 mL/min Model : PGH2 250 Recommended for GC chromatograph (more) detector gas applications and GC, GC/MS carrier gas applications. Designed with automatic cascading capability.

This Eppendorf Refrigerated Laboratory Centrifuge 5804-R was removed from a university lab where it  (more)was surplus to requirements The unit has had a replacement actuator and gas strut fitted by a service engineer who then fully tested the unit. Speed tested to 3600rpm (rotor not included). It was then temperature tested with a digital thermometer (not included) 37ºC our thermometer showed 34ºC.4ºC our thermometer showed 1.0ºC.-9ºC(min) our thermometer showed -5.0ºC. We would suggest that it was the probe placement that caused the temp readings to be a bit inaccurate.

Rigaku X-ray Diffractometer (XRD) Ultima III This system was removed from a university lab where it  (more)was surplus to requirements. The system is in reasonable used cosmetic condition. It has not been powered on at our site due to our on-site risk assessments surrounded X-Rays. Various components and parts are included as listed below, along with a PC setup, although no Rigaku software programs appear to be installed on the PC.However, there are the following software disks included: - Rigaku Basic Software (Cat No.: 9240J101) - Rigaku TTRAX3 and Ultima3 Software (Cat No.: 9240J101) - Rigaku Special Order Software (U30megaP) (Cat No.: 9999) System Specifications: - Model: Ultima III - Cat No.: 2035M410 - Serial No.: DD3654N - 6 Station Holder - Model: SA-HEM3 - Cat No.: 4057J101 - Serial No.: 00563702 - Patlite Beacon - Model: LMS-L (SN-06X03M) - Rigaku DC Motor Controller - SN: DD12866 - Rigaku Long Fine Focus - Type: R01-29-0202 - NC: 9430 022 73201 - No. DK 402688 - Rigaku CBO Cross Beam Optics - Cat No.: 2220B101 - SN: DD12793 - Additional Rigaku parts: - Cat No.: 5738E402 (SN-DD061813) - Cat No.: 2155G101 (SN-DD12804) - Cat No.: 4601K831 (SN-DD12154) - Cat No.: 4253A101 (SN-DD11586 - Vexta Stopping Motor - Model: PK543-A - SN: UR70J32307 PC Setup: - Dell Optiplex 9020 with monitor, keyboard, and mouse - The PC is in working order with all passwords cleared. It contains a few Rigaku files, but no software programs appear to be installed. Included Manuals/Software: - 2 x Rigaku D/MAX 2000/PC Series Instruction Manual - X-Ray Diffractometer Instruction Manual - Rigaku Basic Software (Cat No.: 9240J101) - Rigaku TTRAX3 and Ultima3 Software (Cat No.: 9240J101) - Rigaku Special Order Software (U30megaP) (Cat No.: 9999) Loose spare parts included: - Rigaku Cat No.: 2701E201 (SN-AD08851) - Container of round parts: Rigaku 900003 SH, w/Groove - 2 x Small containers with unknown parts - Scintag Generator Key - Key labeled: "Microscope" - Container of small metals, including: - 1 x Bag labeled "Silicon" - 1 x 640d Silicon Powder - 2 x Tubs UCAR Spectroscopic Powder - 1 x Tub labeled "Tung Flake" - Approximately 20 x small containers of Silicon metal

The Biochrom Expert 96 is a PC- controlled modern design multi-channel microplate reader, for fast p (more)late reading of standard ANSI SBS footprint 96 well, flat, round and v-bottomed plates. The Biochrom Expert 96 has four shaking modes for mixing of solutions and the ability to perform readings at timed intervals ideal for kinetic assays.

The RE40D refractometers is used to easily determine the refractive index of liquids. The measuremen (more)ts are carried out using the total reflection method. With this method, even dark samples can be measured easily. Thanks to the latest technology – no moving parts, durable LED light source and resistant sapphire prism, the RE refractometers are virtually maintenance-free Measure liquids with a refractive index in a range from 1.32000 to 1.7000 Require a minimal amount of sample (approx. 0.4 milliliters) for the measurement Keep the temperature of the samples to be measured between  15.00 and 70.00°C thanks to a built-in Peltier thermostat (no water bath required) Calculate the refractive index of the samples for any reference temperatures based on user-defined temperature functions Show the refractive index of the samples directly in Brix degrees Able to convert the measured values into any units (e.g. Zeiss number) and display them directly in these units Suitable for concentration determinations. Concentrations are due to custom formulas or concentration tables are automatically calculated from the measured refractive index. Deliver statistical evaluations (mean value, standard deviation, relative standard deviation) of the results. Entry of 10 measurement methods. One of these methods is reserved for adjusting the device. Can be easily checked with the built-in check function. This function allows a regular checking of the measurement accuracy without changing the device settings Three serial ports for connecting a printer, a barcode reader and a computer and a connection for controlling an automation unit Including RS-P42 printer

Techne’s Dri-Block heaters provide a safe, dry, constant temperature source in the laboratory. The u (more)nit can be used for incubation, boiling, inactivation, wet ashing, sample concentration, enzyme analysis and many other clinical and industrial purposes.