Water purification equipment

Water bath from 25°C to 100°C for the laboratory The ring baths for columns, Erlenmeyer flasks or be (more)akers are suitable for continuous operation, even unattended, thanks to the standard level and lack of water monitoring. LAUDA Hydro ring water baths are available in five models, all featuring a removable perforated lid with a set of heat-resistant plastic rings. - Operations in a temperature range from 25 to 100°C. - Models H 11 V, H 19 V have been specially designed for safe use in fume cupboards. - The housings are made of stainless steel to allow their use even with chemically aggressive fluids. - Temperature regulation by knob with graduated scale - Lid with set of rings for opening the modular tank - Water level and lack control, for continuous unattended operations - The support rods (length 600 mm, diameter 12 mm), made of stainless steel, are included as standard - Hydro is protected against dry running by an electro-mechanical valve. In case of low water, the heating is stopped In the photo, simple control panel, with knob, graduated scale, warning light and safety valve. Ring opening, to adapt to different types of glassware. Standard water level regulator for continuous operation, even unattended. Safety system in case of water shortage LAUDA evaporization baths are protected against dry running by a cut-off device for lack of water (thermostatic overvoltage). The nut located on the control panel will be used to disarm the security system. Water level regulator as standard Thanks to this accessory, the loss of water inside the instrument (through evaporation) is compensated and the water level is kept constant. Furthermore, it allows use at temperatures below ambient temperatures, with a minimum of approx. 3°C above tap water temperature.

Water bath from 25°C to 99.9°C for the laboratory The shaking water baths of the LAUDA Hydro series  (more)stir laboratory samples with linear or orbital motion, depending on the model. They are reliable instruments, ideal for any laboratory application, be it biological, medical or biochemical, guaranteeing a homogeneous distribution of the temperature. The integrated speed controller enables a load-independent, continuously adjustable stirring movement with soft start. The H 20 SW and H 20 SOW shaking water baths are equipped with a cooling coil as standard. The temperature range can be extended to a minimum of +10°C by connecting them to the domestic water supply or commercially available circulating chillers. Qualitative characteristics - Digital regulation of the temperature and indication via LED display - Load-independent, continuously variable stirring with soft start - Electronic monitoring of the thermoregulator functions, with two fuses for under/over temperature protection - Tank, frame, cover with condensation channel, shaking basket and heater in stainless steel - No dripping condensation – arched insulating lid to reduce heat loss and prevent condensation from dripping onto samples Operation All water baths come standard with a perforated pan and no racks are required. Flasks and containers can be placed directly on the bottom. The drain valve is located on the rear side. Controllers The control panel consists of a large, high-contrast TFT display and a membrane keyboard with four softkeys, protected against dirt and water drops. The menu will guide you on how to use the bain-marie correctly. Esempi applicativi - Bacteriological tests - Molecular biology - Demulsivity studies - Processing of chemical reactions - Thawing - Metallurgical analyses - Incubation of microbiological assays - heating reagents - Environmental studies - Food Processing (QC) - Water quality research - Cytochemistry Accessories available Water level regulator. The heating element is located directly under the sieve plate for even temperature distribution in the tank. Electronic monitoring of the temperature regulator. Two independently operating temperature fuses. Improved visual and audible alarms for increased sample safety. Control elements tilted back for increased splash protection and improved operating comfort. - Perforated plate to place the glassware directly on the bottom. - Fill mark max. to prevent overflows. - Easy removal of sieve plate for cleaning. Highest quality materials: tank interior, lid, sieve and heating element made of stainless steel. Heat insulating lid in stainless steel, double walled with internal curvature to guide the condensate. Limescale deposits inside the water bath can be removed with normal commercial descalers. The internal tray can be easily disassembled and lifted for quick and thorough cleaning. Recommended accessories - Water level regulator. Thanks to this accessory, the loss of water inside the instrument (through evaporation) is compensated and the water level is kept constant. Furthermore, it allows use at temperatures below ambient temperatures, with a minimum of approx. 3°C above tap water temperature.

*Dimensions not added* BMM Weston Steam Generator Model 2616 w/ Lubron Osmostar 250 Water Purifier L (more)ab This system was removed from a university where it was surplus to requirement. Testing on these units is not possible due to the original hard-wiring of the steam generator and the presence of residual water in the filters and pipes. The steam generator will require re-wiring before use. Unfortunately, the copper pipes were cut during removal, rather than being properly disconnected, therefore, will require substantial recommissioning work to get the system up and running again. This system comprises the following: BMM Weston Steam GeneratorModel 2616Serial No. DH14744Two 30KW heating elements123-litre boiler capacity168˚C design temperature6.6 bar operating pressure Lubron Water Technologies Reverse Osmosis SystemModel Osmostar 250Serial No. 10022407Year 2010250 litres per hour, 30 bar working pressure Lubron Softstar Water SoftenerSerial No. 10012208Year 2010

PURE AQUA SERVICE resin for replacement BINDER 6011-0077 BINDER reference: 6011-0077 For BINDER clim (more)atic chamber New material Year of manufacture: 2012

HANNA HI97733 Ammonia Photometer, up to 100.0 mg/L New equipment in its original packaging HI97733 c (more)omes with 2 measuring cuvettes, plastic stoppers and caps and batteries. Range: 1.0 to 100.0 mg/L (NH4+) Resolution: 0.1 mg/L Accuracy at 25°C: ±0.5 mg/L ±5% of reading Method: Adaptation of the “ASTM Manual of Water and Environmental Technology, D1426-92” method, Nessler method Light source: LED with 420 nm narrow bandwidth filter Light detector: Silicon photocell Batteries/Lifespan: 3 x 1.5 V AA / > 800 measurements without backlight On-demand storage: Up to 50 measurements for on-screen recall Auto-off: After 15 minutes of non-use / After 30 min of non-use before a measurement Dimensions/Weight: 142.5 x 102.5 x 50.5 mm / 380 g

WTW OXI 3205 portable oximeter Without probe Waterproof dissolved oxygen measuring instrument Batter (more)y type: 4 x 1.5 V AA rechargeable batteries or 4 x 1.2 V NiMH rechargeable batteries Compensation and correction of atmospheric pressure: Automatic from 500 to 1100 mbar Protection class: IP 67 Screen display: backlit graphic LCD Dissolved O2 measuring range: 0.00 to 90 mg/L Dissolved O2 accuracy: ±0.5% Dissolved O2 resolution: 0.01, 0.1mg/L Temperature precision/accuracy: ±0.1°C Working/Operating/Use Temperature: -5 to 50°C Net weight: 2KG

Rephile NuZar U24 water purification system. Type I and RO water from tap water directly. Two ergono (more)mic dispensers with 2.4″ color touch screen with adjustment of dispensing rate (up to 2 L/min), manual and volumetric dispensing. Automatic cleaning cycles for the reverse osmosis membrane (Cl2 and pH cleaning). Self-maintenance functions for maximum efficiency and lifetime of the reverse osmosis membrane. Stable reverse osmosis permeability over a wide temperature range. Automatic data backup up to 2 years. Easy data transfer via multiple interfaces, such as LAN, USB, etc. Intuitive display: water quality with temperature compensation, volumetric dispensing and flow rate. 10 L quality HDPE storage tank integrated into the system, optionally expandable. Ultrapure Water (Type I) applications: HPLC mobile phase preparation, preparation of reagent blank solutions, sample diluent for GC, HPLC, ICP-MS or other analytical techniques, preparation of buffers and culture media for cell culture, and preparation of molecular biology reagents, etc. RO water applications: washing machine for glassware cleaning, feed water for laboratory animals, feed water for humidifiers, autoclaves, etc., water supply for ultrapure water systems, and hydroponics.