Hitachi Transgenomic Wave L-7000 Series DHPLC System - L-7400 - L-7300 Lab

Hitachi Transgenomic Wave L-7000 Series DHPLC System This was removed from a university lab where it (more) was surplus to requirements. All units power up but have not been tested further as they require connection to a PC with software. Included are; Transgenomic/Hitachi L-7400 UV Detector Model: L-7400Part#: 810-0401Serial#: 1147-080 Transgenomic/Hitachi L-7300 Column OvenModel: L-7300Part#: 810-0301Serial#: 1153-014 Transgenomic/Hitachi L-7200 Auto SamplerModel: L-7200Part#: 810-0201Serial#: 1154-136 Transgenomic/Hitachi L-7200 ChillerModel: L-7200 ACCPart#: 810-3301Serial#: 1134-036 Transgenomic/Hitachi L-7100 PumpModel: L-7100Part#: 810-0101Serial#: 1153-228 Transgenomic/Hitachi D-7000 InterfaceModel: D-7000IFPart#: 810-0091Serial#: 1124-131 ERC Inc Hitachi L-761 Pump Drive Unit/DegasserModel: L-761Serial#: 102895N0775 Additional items included: Transgenomic Wave Ineractive Help System CDPart#: 6700002 Transgenomic Wave System Software Accessories CDPart#: 6700006 Transgenomic Wave System Software Accessories CDPart#: 6700005 Transgenomic Manual Binder x 2

£2,910.00 ex VAT

United Kingdom

hplc systems

Agilent Technologies 1260 Infinity RI Detector/G7800A MDS Quad

This item has just arrived in our stock. Please enquire for further details.

United Kingdom

hplc accessories, hplc systems

Agilent Series 1100 HPLC System

System contains: Solvent tray Vacuum degasser Binary pump Autosampler Thermostatted colomn compartme (more)nt Variable wavelength detector Vacuum degasser: The Agilent 1100 HPLC Degasser features a 4-channel vacuum container, including four tubular plastic membranes, and a vacuum pump. This degasser has a maximum flow rate of 0-10ml/min flow rate per channel and 5-10ml/min at reduced degassing performance. Binary pump: Flow Precision: <0.3 % RSD (typically <0.15 % RSD) Flow Range: Setpoints from 0.001 to 5.0 ml/min, in 0.001 ml/min increments Operating range: 0 – 40 MPa (0 – 400 bar, 0 – 5880 psi) Pulsation: <2 % amplitude (typically <1 %) at 1 ml/min isopropanol at all pressures >1 MPa (> 10 bar, >147 psi) Compressibility compensation: User selectable, based on mobile phase compressibility Delay volume: 180 – 480 µl (600-900 µl with mixer) dependent on back pressure Recommended pH range: 1.0 – 12.5. Solvents with pH <2.3 should not contain acids which attack steel Well-plate autosampler: Safety features: Leak detection and safe leak handling, low voltages in maintenance areas, error detection and display Injection range: 0.01 – 8 µl in 0.01 µl increments Precision: Typically < 0.5 % RSD of peak areas from 5 – 40 µl, Typically < 1 % RSD from 1 – 5 µl, Typically < 3 % RSD from 0.2 – 1 µl Sample viscosity range: 0.2 – 5 cp Sample capacity: 2 × well-plates (MTP) + 10 × 2 ml vials, 100 x 2 ml in one tray, 40 x 2 ml in half tray Injection cycle time: Typically < 30 s using following standard conditions: Default draw speed: 4 µl/min, Default eject speed: 10 µl/min, Injection volume: 0.1 µl Carry-over: Typically < 0.05 % using the following conditions: Column: 150 x 0.5 mm Hypersil ODS, 3 µm Mobile phase: Water/Acetonitrile = 85/15 Column Flow rate: 13 µl/min Injection volume: 1 µl caffeine (=25ng caffeine), 1 µl water to test carryover. Outside wash of needle before injection: 20 sec with water using flush port Thermostatted colomn compartment: Temperature range: 10 degrees below ambient to 80 °C, up to 80 °C: flow rates up to 5 ml/min Temperature stability: ± 0.15 °C Temperature accuracy: ± 0.8 °C (± 0.5 °C With calibration) Column capacity: Three 30 cm Warm-up/cool-down time: 5 minutes from ambient to 40 °C, 10 minutes from 40 – 20 °C Dead volume: 3 µl Communications: Controller-area network (CAN), GPIB, RS-232C, APG Remote: ready, start, stop and shut-down signals, LAN via other series module Safety and maintenance: Extensive diagnostics, error detection and display (through control module and Agilent ChemStation), leak detection, safe leak handling, leak output signal for shutdown of pumping system. Low voltages in major maintenance areas. Variable wavelength detector: Detection type: Double beam photometer Light source: Deuterium lamp Wavelength range: 190 – 600 nm Wavelength accuracy: ± 1 nm Bandwidth: 6.5 nm Linearity:> 2AU (5%) upper limit Flow cell standard: 14 µl volume, 10 mm cell path length, 40 bar

€7,999.00 ex VAT

Netherlands

hplc systems

CTC Analytics Leap HTC PAL Autosampler HPLC Chromatography Lab

This CTC Analytics Leap HTC PAL Autosampler HPLC was removed from a university lab where it was surp (more)lus to requirements. All units are in good cosmetic condition and powered up. We are unable to test the system further at our facility. Autosampler consists of:Autosampler main unit MXY 01-01BSerial No. 113399 Power supply unit MN01-00 Injector unit MZ01-00DSerial No. 980 Control key pad/screen MB 01-00A 2 x pumps MV 02-01ASerial Nos. 2961, 2963 Sample tray 3 drawer storage MP 02-00B Needle wash unitBottle shelf

United Kingdom

hplc autosamplers, hplc systems, automated liquid handling

CTC Analytics Leap HTC PAL Autosampler Heating and Cooling HPLC Lab

This CTC Analytics Leap HTC PAL Autosampler Heating and Cooling HPLC was removed from a university l (more)ab where it was surplus to requirements. All units are in good cosmetic condition and powered up. The CTC Analytics Leap HTC PAL Autosampler was tested with a digital thermometer (not included). We are unable to test further at our facility. Autosampler consists of: CTC Analytics main unit MXY 01-01BSerial No. 113351 CTC Analytics Injector Column MZ01-00DSerial No. 1284 2 x CTC Analytics Pumps MZ01-00DSerial Nos. 3022, 3216 Supercool Box27 sample tray heating and cooling 3 x drawers 20cm x 12cmSerial No. CCO-00103 CCT Analytics Peltier Thermostat unit MN 03-02 CCT Analytics Power Supply MN01-00 CCT Control Pad and Screen MB 01-00A Needle wash unit Included:4 x power leads1 x data cableSolvent shelf with 1 litre glass Scott Duran bottle

United Kingdom

hplc systems, automated liquid handling, hplc autosamplers