Solartron Mobrey 1286 Electrochemical Interface lab

CH Instruments CHI842D Electrochemical Workstation Lab This item was removed from a university where (more) it was surplus to requirement. It is in good cosmetic condition and powers on, we are unable to test it further at our facility.

Adjustable electrode holder arm For electrodes and probes Universal electrode holder arm Great stabi (more)lity thanks to its non-slip circular base of 1.2kg Movement of a radius of 45cm in a 360° plane, this arm receives: 2 electrodes with head Ø 16mm 2 electrodes with head Ø 17mm 1 temperature probe Ø 5mm. Materials plastic and steel Base dimensions Ø 15 x 3cm

The offered instrument / system is fully functional tested and ready to use. FURTHER DETAILS TO FOLL (more)OW

This Solartron Schlumberger 1286 Electrothermal Interface was removed from a university lab where ti (more) was surplus to requirements. The unit powers up but we were unable to test it further at our facility. It is in good cosmetic condition with marks from use. Please note that we have multiples of this unit in stock. You may not receive the one in the photos but will receive one in near-identical working and cosmetic condition. If you would like to see photos of the exact unit you are receiving upon purchase before it is shipped, we would be happy to provide this.

EG&G Polarographic Analyzer System Model 384B with 303A Dropping Electrode These were removed fr (more)om a university lab where they were surplus to requirements. Both units have been powered up but we were unable to test them further at our facility. Included are; 1x EG&G Polarographic AnalyzerModel 384BThe unit powers on and is in good cosmetic condition. 'BLANK SWV' appeared on the screen after the analyser had powered up. None of the buttons appeared responsive. 1x EG&G Stating Mercury Dropping Electrode (SMDE, DME, HMDE)Model 303AThe unit powers on and is in good cosmetic condition. We were unable to test it. Accessories: 1x EG&G Operating DisketteRevision: F0The unit is in good cosmetic condition. The diskette goes into the back of the polargraphic analyser in the disk drive. 'BLANK SWV' appeared on the screen after the analyser had powered up. 1x EG&G Polargraphic Analyzer user manual 1x EG&G StirrerModel 305The unit powers on via the SMDE and is in good cosmetic condition.The stirrer works in MANUAL mode, and both the slow and fast speeds are working. We could not get the stirrer to work in AUTO mode. 2x Ametek Data DiskModel 394Rev 2.01The units are in good cosmetic condition, they are not compatible with the unit. more likely for a PC, 7x 25ml Glass cupsThe units are in good cosmetic condition 5x 50ml Glass cupsThe units are in good cosmetic condition. 1x Ribbon cables RS232The unit is in good cosmetic condition 1x Cell compartment controller cableThe unit is in good cosmetic condition,it provides power from the 384B Analyser to the 303A SMDE

This ALC T530 Fixed Angle Centrifuge Rotor was removed from a university lab where it was surplus to (more) requirements. The unit is in good cosmetic condition with marks from use. it has not been tested and will need to be inspected for safety before it is used. Max rpm 14500Max load 0.080kg20 x Tube well with 11.20mm diameter. The number on the lid - 6758

This Leitz Weltzar Microtome was removed from a university lab where it was surplus to requirements. (more) The unit is in reasonable cosmetic condition and all the levers and dials move freely.

Air flow: 2300 – 2500 m³/h Dimensions (WxDxH): 2400 x 700 x 1800 mm Internal dimensions (WxDxH): 230 (more)0 x 650 x 600 mm Equipped with a Fraser Anti-Static Bar

KNF SIMDOS 10 IP65 UFEM 1.10 FT.18RC2 Diaphragm Liquid Dosing Pump Flow Rate Range 1 to 100 ml/min  (more)Programmable Dosing 1 to 999 ml Maximum Suction Height 3 mWg Features - Small footprint - Simple, intuitive operation - Manual, analog control - Self-priming, can run dry - Consistent, reliable flow rate - Simple calibration - Cycle mode - Adaptable to fluid characteristics - Start/Stop through logic control (TTL) - Reset/Prime through logic control (TTL) - Output signal fault alarm The KNF SIMDOS 10 IP65 UFEM 1.10 FT.18RC2 Diaphragm Liquid Dosing Pump is liquid dosing/metering diaphragm pump. Offers wetted material combinations for optimal chemical resistance. Equipped with manual, analog, and RS-232 controls with LCD graphic display. INCLUDED: The KNF SIMDOS 10 IP65 UFEM 1.10 FT.18RC2 Diaphragm Liquid Dosing Pump includes: - Connection Kit (Hose and Screw-in Fittings) - Remote Control Cable - Filter - Power Cord - Operator's Manual - Manufacturer's Documentation - 2 Year Manufacturer's Warranty

Benchmark BSH5002-2B myBlock ll - digital dry bath with 2 Quick-Flip blocks (BSWCMB) for tubes (0.2  (more)to 2.0ml, PCR strips and PCR plates, 115VBenchmark’s myBlock series is a “next generation” product line that introduces several major advantages over traditional dry baths. They are the first digital dry baths to include advanced microprocessor controls, timed or continuous operation and a removable hinged lid. In addition, an optional external temperature feedback probe can be positioned directly inside a sample tube, providing real-time control and monitoring of actual sample temperature.The myBlock’s transparent lid helps to promote better uniformity and minimize temperature stratification in the block by maintaining a warm air jacket layer. It also helps to reduce energy consumption by minimizing heat loss to the environment. The hinged lid can be flipped open (to the rear), or easily removed (lifted off) to accommodate taller tubes. Both the single and dual block models can be ordered in a configuration that includes our unique Quick-Flip™ blocks (BSH5001-1B and BSH5002-2B). These universal blocks accept tubes from 0.5 to 2.0ml and, with just a quick flip to the other side, accomodate 0.2ml tubes, PCR strips or (in the dual block model only) a PCR plate. Other blocks are available for tubes up to 50ml. Click Here to View Product Video INCLUDED: The Benchmark BSH5002-2B myBlock ll - digital dry bath with 2 Quick-Flip blocks (BSWCMB) for tubes (0.2 to 2.0ml, PCR strips and PCR plates, 115V includes: - 2 x BSWCMB Quick-Flip Blocks - Power Cord - Operator's Guide - Manufacturer's Documentation - 2 Year Manufacturer's Warranty