Laboratory furniture

Cabinet for the storage and isolation of poisons, toxic chemicals and CMRs. Made entirely of FE P01  (more)electro-galvanized sheet steel (Skin passat), thickness 10/10 mm, cold press bent and painted, after degreasing treatment, with a first application of epoxy primer and with 2 subsequent applications of thermosetting powders and subsequent passage in a thermal tunnel at 200°C. - 2 plastic-coated steel shelves (max load 5 kg evenly distributed) - Double layered swing door, lock and key - Opening of the doors with an angle greater than 110° which allows the extraction of the shelves without having to tilt them - Predisposition for wall mounting - Possibility of fixing in a safety cabinet (on the shelf or on the back wall of the cabinet) - Locking with safety lock and key - Can be used as a wall unit to store harmful products or inside a 1- or 2-door wardrobe - Safety symbols indicating the presence of poisons inside

Vickers-Armstrong Pedestal Hardness Tester This was removed from a university lab where it was surpl (more)us to requirements. The unit is in reasonably good cosmetic condition with marks from use. The system is mechanically sound, but we were told by the lab that the diamond might be damaged. We have been unable to confirm or deny this.

This ThorLabs PBH52512 - Performance Series II Breadboard was removed from a university lab where it (more) was surplus to requirements. The unit is in good cosmetic condition with marks from use but has not been tested. Flat Dimensions: 1200 x 750 x 110 mmSerial Number: 079523Tapped Hole Size: M6Hole Centre Pitch: 25 mm

This Bigneat F3-XIT-D Powder Weighing and Handling Cabinet was removed from a university lab where i (more)t was surplus to requirements. The unit powers up and is in good working order. It is in good cosmetic condition with some marks and paint chips/rust from use.

This unit is being sold on behalf of a client in Glasgow. This unit was a special commission inspire (more)d by the Glasgow Transport Museum. It is a unique, bespoke piece of furniture. It is in very good cosmetic condition. It has a very strong well made box section chassis, painted steel legs and the top structure is made of a mixture of woods. There are three good sized lockable drawers on the rear, with keys present. There are cable access points on the tabletops in both sections to allow cables to be run, from underneath, to any equipment that is to be used. The unit could be split into two sections to ease removal. The access to the building for removal is good with large doors and good parking. Viewing of the unit can be made with prior arrangements. This is a heavy item so a van with a tail lift is recommended. We estimate it is around 350 kg. DIMENSIONS :- 351cm (l) x 120cm (w) x 275cm (h). The normal terms and conditions do not apply to this item. This item is non returnable and non refundable.

This Fumecare DW5-90 Downflow Workstation was removed from a university lab where it was surplus to  (more)requirements. The unit powers up and the airflow functions are in good working order. It is in good cosmetic condition with marks from use.

Melles Griot Optical Table Isolator Product No. 070WSS01 This item was removed from a university lab (more)oratory where it was surplus to requirements. The isolator is in good cosmetic condition and is in stable structural condition. The frame includes wheels for easy mobility. Specifications: - Overall Dimensions: L90 x W75 x H74.2 cm - Tabletop Dimensions: 90 x 75 x 6 cm - Distance from Floor to Tabletop: 74 cm - Frame Dimensions: L89 x W74 x H67.5 cm - Measurement Type: Imperial Includes:- Mobile frame with wheels Product No.: 070WSS01Serial No.: 2443

Carbolite Type OAF 11/1 Ashing Muffle Furncace This was removed from a university lab where it was s (more)urplus to requirements. The unit powers up and is in full working order to 1100˚C. It is in good cosmetic condition with marks from general use.

4 x Melles Griot Optical Table Passive Isolator Legs This was removed from a university lab where i (more)t was surplus to requirements. The units are in good cosmetic condition but have not been tested. Product#: 07 OTi055Serial#: 700247Load Capacity: 1100kgAir supply pressure: 80PSi

TMC Micro-G 63-530 Antivibration Table Lab This item was removed from a university where it was surp (more)lus to requirement. It is in good cosmetic condition, we are unable to test it further at our facility.

Labcaire HLF18 Laminar Flow Cabinet This was removed from a laboratory where it was surplus to requi (more)rements. The unit powers up and is in full working order. It is in good cosmetic condition with some minor marks from use. Socket tester not included. Internal dimensions:Dx50 Wx183 Hx72cm

Esco Laminar Ductless Flow Cabinet Clean Bench Model AHC-4D1-1 Lab This item was removed from a univ (more)ersity where it was surplus to requirement. In excellent cosmetic condition with very little signs of previous use. This unit is in full working order. The previous owner reported the cabinet had done very little work and was working normally. It was last serviced by on 18-04-2024 Please take note of the following specifications: - Usable work area: 0.59 m^2- Air volume: 815 cm^3/h- Work height: 77 cm from the floor- Prewired and fittings for UV lamp (UV lamp not included)- The cabinet is mounted on a sturdy trolley with four castors, two of which can be locked.- Two pre-filters are installed in the roof panel. Order Code CR/PF-2 for a pack of 6.

Leica EG1140H Paraffin Embedding Center & EG1140C Cold Plate This was removed from a university  (more)lab where it was surplus to requirements. We tested both units with a digital thermometer (not included). 1 x Model - EG1140 HCat no. 038831690Top tray - 30 x 15.5 x 8cmSide trays - 26 x 16.5 x 4cm The unit powers on and heats up on side plates and top, the thermometer was showing temperature readings of up to 50°c when on a setting of 55°c. The light does not work. 1 x Model - EG1140 C-1Cat no. 038831679The unit powers on with the plate cooling. The temperature cooled to as low as -4°c after running for around 20 minutes. Both units are in a reasonable, used cosmetic condition with marks and stains.

Chart MVE 500 Series MVE510AF-GB Liquid Nitrogen Tank Dewar This was removed from a university lab w (more)here it was surplus to requirements. The unit powers up and we have the password available. We were unable to test it further. It is in good cosmetic condition with marks from use. Model no. MVE510AF-GBRef - 11905075SN - CAB2111410005 Internal dimensions - D91 x W52.5cm6 x Triangular storage holders sized 22 x 23 x 64cm (Blue spacers inside drawers)

Foster + Freeman MVC3000 Fuming Cabinet This item was removed from a university lab where it was sur (more)plus to requirements. The cabinet powers on and is in reasonable cosmetic condition. Upon powering up, the cabinet initiates a 5-minute Mini Purge, after which the electronic door can be opened. However, the system displays a 'Filter Fault' status after startup, indicating a missing filter.Therefore, further testing could not be conducted. There is no filter fitted, the unit should work fine with one in. Specifications:- 1 Shelf: 74 x 58 cm - 2 Baskets: 57 x 30 x 15 cm - Underneath space: 75 x 64 x 32 cm Model: MVC3000Serial No: 3175

Baker Ruskinn Invivo2 500 Hypoxia Glovebox Workstation on Trolley This system was removed from a uni (more)versity lab where it was surplus to requirements. The unit powers up and has been tested with a digital thermometer (not included). Both the CO2 & O2 sensors are functional. It is in good cosmetic condition internally and externally. The internal light would not work.Support trolley with castors 141 x 71 x 83cm (l x w x h)

Under-bench cabinet depth 51cm - Length 96cm Laboratory cabinet Length: 96cm Depth: 51cm Height: 71c (more)m In melamine 2 doors On casters (hidden by the finishing profile) In good condition Slightly oxidized hinges and some small traces of wear (see photos)

Under-bench cabinet depth 51cm - Length 144cm Laboratory cabinet Length: 144cm Depth: 51cm Height: 7 (more)1cm In melamine 3 doors On casters (hidden by the finishing profile) In good condition Slightly oxidized hinges and some small traces of wear (see photos)

Chariot inox 2 plateaux - dim. ext. L x l x h (mm) : 850 X 540 X 940 4 roues pivotantes anti-bruit ø (more) 100 mm, dont 2 à frein 4 butoirs d'angle Capacité de charge : 60 kg/chariot et 30 kg/étagère Equipement Neuf, encore emballé

USBECK Aluminum Spindle Lift 20 x 20 cm Lifting Stand, Laboratory Lifting Table Tabletop dimensions: (more) 200 x 200 mm With traces of wear

Under-bench cabinet depth 51cm - Length 65cm Laboratory cabinet Length: 65cm Depth: 51cm Height: 71c (more)m In melamine 2 doors On casters (hidden by the finishing profile) In good condition Slightly oxidized hinges and some small traces of wear (see photos)

Under-bench cabinet depth 51cm - Length 65cm Laboratory cabinet Length: 65cm Depth: 51cm Height: 71c (more)m In melamine 4 drawers On casters (hidden by the finishing profile) In good condition Slightly oxidized hinges and some small traces of wear (see photos)

Under-bench cabinet depth 51cm - Length 65cm Laboratory cabinet Length: 65cm Depth: 51cm Height: 71c (more)m In melamine 2 doors On casters (hidden by the finishing profile) In good condition Slightly oxidized hinges and some small traces of wear (see photos)

Under-bench cabinet depth 51cm - Length 65cm Laboratory cabinet Length: 65cm Depth: 51cm Height: 71c (more)m In melamine 2 doors On casters (hidden by the finishing profile) In good condition Slightly oxidized hinges and some small traces of wear (see photos)

5 Level Shelf Ht 1750mm x P400mm CODIGEL Shelving Lot composed of: An in-line shelf: 2x856mm on 5 le (more)vels - L = 1682mm (CODIGEL reference: EA-0146) Very solid, durable and hygienic shelving with 15 micron anodized aluminum structure and high density polypropylene shelves They withstand temperatures from -30°C to +75°C, as well as distributed loads of 100kg/m or 120kg per shelf Adjustable feet New equipment in its original packaging