Perkin Elmer Envision 2103 Multilabel Reader

This Thermo Electron Corporation Multiskan EX Model 355 Microplate Reader was removed from a univers (more)ity lab where it was surplus to requirements. The unit powers up and performs a self-check test on start-up, we are unable to test it further at our facility. It is in good cosmetic condition with marks from use.

This item has just arrived in our stock. Please enquire for further details.

Accuris MR9611 SmartReader Microplate Reader UV-Vis with Cuvette Port & PC Software Included For (more)mats Accepted 96-Well, 384-Well Flat Bottom Plates, Cuvettes Display 10-inch High Resolution Color Touch Screen Wavelength Range 200 - 1000 nm, 1 nm Steps Features - Intuitive, 10-inch color touch screen control panel - Accepts both 96 & 384-well plates as well as cuvettes - Monochromator-based system - No filters required - Wavelength range from 200 to 1000 nm - Stand-alone design - No PC or special software required - USB port for flash drive data transfer - SmartDrop™ Accessory Plate available for DNA/RNA Quantification/Purity Analysis The Accuris SmartReader UV-Vis Microplate Reader with Cuvette Port (Model MR9611) has been designed with ease-of-use and fast results in mind. This instrument brings extensive capabilities to the lab bench and is designed for the busy lab with multiple users. The large touch screen command center is extremely user-friendly and allows for fast set up of new protocols, as well as modifying and running existing protocols. The monochromator-based optical system allows for precise selection of wavelengths from 200nm to 1000nm, with no filters required. This range makes the SmartReader UV-Vis useful not only for typical ELISA , Bradford Lowry, and turbidity assays but also for more advanced applications such as quantitation of nucleic acids and proteins. The SmartReader UV-Vis can be set for Endpoint, Kinetic and Spectral Scanning assays. The MR9611 is designed for efficient processing of multiple samples and accepts standard 96 well plates, 384 well plates, as well as cuvettes for high density screening. The plate layout interface allows for a quick and intuitive setup of a plate well’s contents. Users can highlight and label multiple wells to save time. The display shows a graphical representation of the plate. Users can label each well as required for: “known standard”, “unknown sample”, “blank well” , “QC Control well”, “positive control”, “negative control”, and “empty”. Controllable plate shaking and incubation allow for optimization of assay results. Theshaking speed can be controlled at different intensities with options for timed and pulsedshaking before a reading, or in between readings when performing a kinetic assay. Thelinear motion efficiently and uniformly mixes all samples in both 96 and 384 well plates.Temperature can be controlled from ambient +5°C up to 45°C, allowing for the processingof enzyme kinetics, and bacterial growth assays. INCLUDED: The Accuris MR9611 SmartReader Microplate Reader UV-Vis with Cuvette Port & PC Software Included includes: - SmartReader PC Software for MR9611 - Cuvette Port - Power Cord - Operator's Guide - Manufacturer's Documentation - 2 Year Manufacturer's Warranty

Labtech LT-4000 Microplate Reader This was removed from a university lab where it was surplus to re (more)quirements. The unit powers up but we were unable to test it further at our facility. It is in good cosmetic condition with minor marks.

This system measures the growth of micro-organisms. This system features a unique incubator incorpor (more)ating a liquid circulation heat exchanger which provides constant temperatures to all wells, a linear shaker to assure good mixing in each well, a sensitive reader that measures turbidity, a technique more sensitive than a spectrophotometer. Additionally, the system is equipped with 8 filters to measure specific wavelengths, two covered honeycomb plates may be run at one time that makes it possible to run 200 samples simultaneously. Linear range: 0.0 – 2.0 A (max deviation <2%) Noise: max 0.002 A at 0.0 A Drift: max 0.003 A Resolution: 0.001 A Warm-up time: 30 min Light source: Quartz-Halogen lamp 8V/50W Filters: 405, 420, 450, 492, 540, 580, 600 nm and wide band filter 420 – 580 nm Half band with: 3 – 10 nm Detector: Silicon photocell Microplate type: Honeycomb 2 microplate, 100 wells per plate Capacity: 1 – 2 microplates Maximum volume: 400 µL/well Incubating temperature: 1.0 – 60.0°C, selectable with steps of 0.1°C. (Depends on the ambient temperatue. Bioscreen can go 6°C below or 30°C above ambient temperature up to a max of 60°C) Temperature uniformity: ± 0.1°C Heating time from 20°C to 30°C: 30 min Heat transfer fluid required: Mixture of ethylene glycol and water 1:1 Dimensions (WxDxH): 620 x 380 x 230 mm Weight: 22 kg

The offered instrument / system is fully functional tested and ready to use. FURTHER DETAILS TO FOLL (more)OW

Angular rotor for centrifuge 48 x 4g SORVALL HERAEUS Autoclavable 138°C 22000 rpm 48X4g With lid

AM4 Digital is the solution for laboratories that need precise control of sample temperature and max (more)imum reproducibility. Among its qualitative features we can find the possibility of connecting the Pt100, Pt1000 probes and the VTF digital thermoregulator, for accurate and direct control of the sample temperature. The CerAlTop™ plate, in aluminum alloy covered with a ceramic layer, guarantees a homogeneous and fast heat transfer over the entire surface, as well as high resistance to chemical agents and scratches. Designed to last and give you the comfort you need in the laboratory, the AM 4 Digital Multi-Position Magnetic Stirrer is covered by a 3-year warranty (online product registration required). In short: - Ceramic coated aluminum alloy - Electronic speed regulation up to 1500 rpm. - Stirring volume (H2O) up to 20 liters per position. - Temperature up to 310°C. - Connections for PT100, PT1000 and VTF 1 - Aluminum alloy plate with ceramic coating  2 - Main switch 3 - Speed ​​control knob 4 - Temperature control knob 5 - Visualization A - Probe LED B - Temperature setpoint LED The powerful brushless motor ensures stable and reliable stirring. The patented SpeedServo™ technology ensures constant speed even with variations in fluid viscosity. The consistently precise stirring speed, from chemical reactions to sample preparation, is adjustable from 50 to 1500 rpm for volumes up to 20 liters (H2O). The LED displays will always allow you to easily read the values, from any angle. For maximum precision, by connecting the external PT100 or PT1000 sensors you can directly thermoregulate the sample with an accuracy of ±1.0°C. Using VTF Digital instead you can control the temperature with a precision of ±0.5°C up to a maximum of 300°C. In this regard, various accessory packages are available. You will find all the combinations at the bottom. Safety during heating: - 'Hot surface' alarm when temperature exceeds 50°C, even when inactive. - Overtemperature alarm The new spherical caps replace the oil baths and heating mantles. They adapt perfectly to both the 135 mm plate and the shape of the tubes, ensuring rapid heat transfer. To improve protection and reduce heat loss, VELP has designed new PTFE covers. The MultiAlublock™ and new MonoAlublock™ solutions are ideal for carrying out multiple stirring and heating analyzes in laboratories with limited space and time. Download the dedicated brochure for the complete list.

The mass standard is the foundation of accurate mass measurement, as it affects the quality and reli (more)ability of results in many areas. Its role in maintaining uniformity and in meeting measurement standards is crucial, making the mass standard an indispensable metrology component. Varied Standards: The set consists of 12 flat polygonal sheets and 4 cylindrical standards, providing a wide range of calibration options. High-Quality Accessories: The set also includes 2 pairs of tweezers, 1 brush and 1 pair of gloves, facilitating precise and safe cleaning and handling of the standards. Plastic Packaging: The weights are delivered in a durable plastic case, ensuring their safe storage and transport. *The mg unit mass standards are flat polygonal sheets. **The 1 mg, 2 mg and 5 mg mass standards are made of aluminum.

Pack of 2 cages for termodesinfectadora with a lid.