Memmert BE500 Inkubator Incubator Brutschrank 108L 70 °C 900W 2x Einlegeböden

Including Three-Tier Cell Roller Base Capacity : 821.2L Cabinet Material: Cold-rolled steel, powder- (more)coated cabinet Shelves: 6 supplied  (19 max.) Temperature ramp and soak, up to 24 steps Temperature Range: 0° to 60°C Temperature Resolution: 0.1°C Temperature Uniformity: ±0.3 at 25° to 37°C Temperature Sensor: RTD Temperature Accuracy: ±0.1 at 25° to 37°C Compressor: 1/4hp, air-cooled Relative humidity control via steam generator from above ambient to 95% at 37°C Heat Output: 1750W (6000 BTU/hr.) at 220V Adjustable defrost timer; factory set for two 15-min. defrost cycles/24 hr. Refrigerant: CFC-free, R134A Certifications/Compliance: ICH, FDA, TAPPI, ASTM™ Dimensions (d x w x h): 782mm x 1011mm x 2034mm Dimensions Internal (d x w x h): 686mm x 787mm x 1524mm 220V / 50Hz Three-Tier Cell Roller Base (15 positions) Dimensions (d x w x h): 620mm x 757mm x 706mm 220-240V / 50-60Hz

Sanyo MIR-153 Cooling Laboratory Incubator Lab This item was removed from a university lab where it  (more)was surplus to requirements. It is in reasonably poor cosmetic condition with noticeable damage. Due to a faulty control panel, we were unable to set the temperature to test. Therefore, its sold as Spares or Repairs.

New Brunswick Innova Model 4330 Incubator This was removed from a university lab where it was surpl (more)us to requirements. The unit heats but does not cool. The shaking works, but requires maintenance. It is sold for spares/repairs.

Sanyo MCO-18AC CO2 Incubator This was removed from a university lab where it was surplus to requirem (more)ents. The unit powers up and has been tested with a digital thermometer (not included). It is in good working order. It is in good cosmetic condition. This unit has been professionally serviced and is in full working order. The service report is available on request.

Sartorius Certomat BS-1 Incubator Shaker This was removed from a university lab where it was surplus (more) to requirements. The unit powers up and is in working order, but it is out of calibration by a few ˚C. It will require calibration upon installation. The service menu is password-protected. The shaker is in good working order. The system is in good cosmetic condition with minor marks.. This is the heating only model. It will not refrigerate.

Baker Hypoxycool Culture Media Hypoxia Conditioner This was removed from a university lab where it w (more)as surplus to requirements. The unit powers up and is in full working order. It is in good cosmetic condition and is very clean inside. It was tested temperature tested (thermometer not included), but no other functions would run without gas being connected. We are unable to do that at our facility. Internal dimensions 38 x 38 x 30cm (LxWxH)

Dimensions drawer cabinet (WxDxH): 1200 x 480 x 1350 mm Dimensions wall cabinet (WxDxH): 1200 x 480  (more)x 900 mm

Twinbird Corporation SC-UE15R FPSC Module UE15 with Heat Absorption Ring This item was removed from  (more)a university lab where it was surplus to requirements. It is in good cosmetic condition but has not been powered on, as it requires wiring into a power supply. Specifications:- Model: SC-UE15R - Serial No.: 3 5Z16

This Jobin Yvon Symphony Solo Fast CCD Detector was removed from a university lab where it was surpl (more)us to requirements. The unit powers up and is in good cosmetic condition with minor marks from use. Model number- SYMPHONY-SOLO-FASTSerial number- 1074

Perkin Elmer Clarus 500 GC-MS Gas Chromatograph Mass Spectrometer System Lab This system was removed (more) from a university lab where it was surplus to requirements. The system has been professionally serviced and is in good working order. It is in excellent cosmetic condition with minor marks. The full-service report is available on request.

Branson Sound-proof EnclosureAlthough ultrasound is above the audible range of the human ear, mechan (more)ical noise occurs when liquids are treated ultrasonically. The noise may be disturbing in a room with low ambient noise level if exposed for prolonged periods of time. Operating the Sonifier® in the Soundproof Enclosure can minimize mechanical noise produced by ultrasonic processing. The sturdy cabinet is lined with waterproof, sound-absorbing material, which is impervious to most solutions or laboratory regents and can be easily cleaned. A fully-transparent door enables viewing of the process while limiting the noise to an acceptable level. The decibel rating will lower by 20-25db. Openings at the top and bottom of enclosure make for easy access for use with either a cup horn or standard probes. Comes with inside column and adjustable clamp plate. Side panel allows for placement of horns, tips and manuals. INCLUDED: The Branson Sound-proof Enclosure includes: - Manufacturer's Documentation - 1 Year Manufacturer's Warranty