Eaton Intelligent Power Software Suite 103004871 Rev 10

The offered instrument / system is fully functional tested and ready to use. FURTHER DETAILS TO FOLL (more)OW

The offered instrument / system is fully functional tested and ready to use. FURTHER DETAILS TO FOLL (more)OW

The PowerPac Basic power supply is designed to provide constant voltage or current electrophoresis a (more)pplications. The power supply operates at the value specified for the constant parameter, with limits for the other parameters. To prevent damage to the electroferese cell, the PowerPac Basic provides automatic crossover to constant current or constant voltage depending on which set limit is first reached. If the set limit of the non constant parameter is reached, the power supply will switch, making the limiting non constant parameter the new constant. Output specifications: Voltage: Adjustable from 10 to 300 volt, in 1 volt increments Current: Adjustable from 4 to 400 mA, in 1 mA increments Power: 75 W Dimensions (WxDxH): 210 x 245 x 65 mm Weight: 1.1 kg

Output Range: 1–500 V (minimum step size 1 V) 1–500 mA (minimum step size 1 mA) 0.1–50 W (minimum st (more)ep size 0.1 W) Automatic crossover on reaching set limits. Accuracy: Voltage: ± 2% or ± 2 volts Current: ± 2% or ± 2 mA Wattage ± 2% or ± 0.2 watt Drift: < 1% in 8 hours after 30 minute warm-up  with constant supply voltage Circuit Protection: Open Circuit; Short Circuit; Thermal Protection; Over Voltage, Current, Wattage Safety: Load Detection Thermal Shutoff (with optional temperature probe) Isolated Floating Ground Memory Control: Non-volatile, up to 24 hours; Custom Methods Stored to RAM Computer Interface: RS232C Dimensions (WxHxD): 165 x 180 x 205 mm Weight: 2.9 kg

Multi Job Lot Mixed, Centrifuge, Shaker, Power Supply, Water Bath etc This job lot of items come fro (more)m a variety of university laboratories. The items were no longer required, collected from various store rooms and facilities. None of these items have been tested at our site - it is likely that some will be spares/repairs, but we anticipate that a reasonable amount should operate well. None of these items have been PAT or electrical safety tested. For this reason, we have marked these as spares/repairs as they should not be used without appropriate electrical safety checks. They are sold as a spares/repairs bundle and further investment in each individual product may be required. It is an excellent opportunity for anyone looking to benefit from individual equipment resale. The units have not been tested at all. Included are; ITEM-38313 Eaton EX3000 RT Uninterupted Power Supply with 3 x Eaton EX EXB Battery UnitsITEM-38562 GE Digital Energy LP 5-11ITEM-37843 Hettich Mikro 12-24 CentrifugeITEM-37844 Genofuge 16 M CentrifugeITEM-37845 Heraeus Biofuge 13 Centrifuge ITEM-37803 Stuart Scientific S1 20H Oven ShakerITEM-37804 Pharmacia Frac-100 Fraction CollectorITEM-37805 Buchi HB-140 Boiling BathITEM-37806 Fisher Scientific PowerGen 125 HomogeniserITEM-37807 Edwards RBF1 Vacuum Pump CompressorITEM-37846 Mitsubishi Video Copy Processor P67EITEM-37847 Sony Video Graphic Printer UP-895CEITEM-37848 Denver Instrument Company DE Series DE SeriesITEM-37810 Collection of 6 Chromatography Columns, Pharmacia Uppsala LKBITEM-37849 LaCie D2 HD QuadraITEM-37850 Zeiss Stemi SV 6ITEM-37851 FisherBrand WhirliMixerITEM-37500 Model R100 Rotatest Shaker LuckhamITEM-37510 Sorvall PicoITEM-37509 Grant JB1 Water BathITEM-37508 Grant JB1 Water BathITEM-37814 3 x Pharacia LKB Frac 100 Fraction CollectorsITEM-37507 Polaroid 545 Land Film holder With Filter Box

Tufvassons 3 Phase Autotransformer Lab This item was removed from a university where it was surplus  (more)to requirement. It is in good cosmetic condition and powers on, we are unable to test it further at our facility.

The offered instrument / system is fully functional tested and ready to use. FURTHER DETAILS TO FOLL (more)OW

Max speed: 16400 rpm Temperature range: -9°C to 40°C Max centrifugal force: 25000 rcf Max kinetic en (more)ergy: 6100 Nm Max density of samples: 1.2 g/ml Dimensions (HxWxD): 250 x 310 x 597 mm Weight: 34.8 kg Equipped with: 1x Eppendorf FA-45-30-11 Aerosol-tight lid 1x Eppendorf FA-45-30-11 fixed angle rotor (max 14000 rpm; 30x 1.5 mL/2.0 mL micro tube capacity)

Potteau Wall cabinet L. Gray 600x370x800

Stylcam 200R High Speed Rotary Press Simulator System w/ PC &amp; Software Lab This system was remov (more)ed from a university where it was surplus to requirement. It is in good cosmetic condition with all units powered on, we are unable to test it further at our facility. This system includes a PC set-up with the following software installed: - Analis 2.01.16 Version This system cannot be exported and the eventual buyer will be subject to a disclaimer.

OVAN MultiMix Heat MMH50 magnetic digital stirrer. Heated multi-shaker on a single platform with 5 p (more)ositions, with a single electrical connection and independent operation of each place. Speed range from 200 to 1200 rpm. Temperature range from 30 to 400 ºC. Maximum capacity per square 2L. Plate dimensions of 100 * 100 mm for each square. OVAN MultiMix Heat MMH50 magnetic digital stirrer. Heated multi-shaker on a single platform with 5 positions, with a single electrical connection and operation independently of each position. Adjustable speed and temperature, controlled by microprocessor. High precision with integrated internal Pt100 probe. LED display. Keyboard with membrane buttons, sensitive to the touch. The selected parameters are kept in the memory of the equipment even when it is turned off.

HRP EX Platform Wherever high readability and precision are important. Wherever good repeatability i (more)n harsh industrial conditions matters. HRP EX Platforms are the ideal solution for any type of industry. Repeatability that cannot be repeated by others HRP EX Platforms have a built-in internal adjustment system. Automatic internal adjustment guarantees the best quality of work and repeatability of results. You save time and avoid the inconvenience of manual adjustment. Hazardous areas are their natural environment HRP EX Platforms have been developed in accordance with Directive 2014/34/EU and the IECEx scheme and, depending on their design, can operate in environments containing explosive gases or dust, classified as zones: 2 and 22. We have equipped them with an intrinsically safe RS 485 communication interface, which allows the platform to work with the PUE HX5.EX weighing meter. To power the platforms, we have dedicated intrinsically safe PM02.EX-1-2 or PM02.EX-2-2 power supplies. Use the potential HRP EX Platforms work with the PUE HX5.EX weighing terminal and are compatible with RADWAG receipt printers. In addition, you will match them with appropriate antivibration tables from our offer, and thus increase the readability of your measurements. The use of stainless steel for the construction of the pan guarantees you a long life of the platform. Fearless of its contact with moist objects or accidental splashing.