Gast Air Compressor BS5169 III E

Keith Blackman LTD Tornado Centrifugal Fan This system was removed from a university lab where it w (more)as surplus to requirements. The unit powers on and is in working condition. We are unable to test it further at our facility It is in reasonable cosmetic condition, with some parts spray-painted red and green. Specifications:- Serial No.: U.566861 - Motor No.: 559681 - Date: 1962 - RPM: 2900

This Atlas Copco Workplace Air System Type - GA5 was removed from a university lab where it was (more) surplus to requirements. The item is in a reasonable, used cosmetic condition but we were unable to test it at our facility. It will require a cable and plug fitting. While the system is operational a number of issues were found during a service. The service was then abandoned. It is sold for spares/repairs. The inside of the machine was found to be oily, the oil level was too high and there was water in the oil, the drive belts are cracked and needreplacing and the oil cooler fan is seized. Water was found in the oil. The main cooling fan is seized - this needs replacing. The compressor looks to have been stood for some-time. Specs;Year 2005, 10 bar, 11.5l/s 0.69m3/m 5.5kw 3 phase. 308kg.

Jun-Air Model 6/6-4 Quiet Running Compressor Lab This item was removed from a university where it w (more)as surplus to requirement. It is in good cosmetic condition and powers on. We are unable to test it further at our facility.

Woods 63KO Variable Pitch Aeronautical Engineering Wind Testing Tunnel This was removed from a univ (more)ersity engineering department where it was surplus to requirements. The tunnel was dismantled when we collected so no testing was carried out, but we were told that it was still in operational condition prior to dismantling. It is in five sections: Section 1- Main Power/ Fan Unit.-405 kg. 120 cm x 120 cm x 150 cm. Outlet flanges 63 cm inside diameter. 3 phase 5 pin 415V motor. Section 2- Silencer Unit- 160 kg. 127 cm x 91 cm x 131 cm. Flanges are 79 cm and 63 cm inside diameters. Section 3- Air Intake Funnel- 155 kg. 170 cm x 121 cm x 145 cm .Apertures are 41cm x 41 cm and 80 cm x 80 cm. Section 4- Large Tunnel Section-155 kg. 118 cm x 73 cm x 120 cm. Apertures are 41 cm x 41 cm and 64 cm diameter internal. Section 5- Work Access Unit-85 kg. 55 cm x 55 cm x 160 cm. This has 8 openings 30 cm x 60 cm. It comes with a variety of doors, 8 in total.

4 X ZIEHL-ABEGG Type - EWRG 210 LB/4 Industrial Blower Fans These were removed from a university lab (more) where they were surplus to requirements. All 4 Units power on and are powerful they are in Good Condition with Minimal Wear and just a few minor scratches here and there Model - EWRG 210 LB/4

Atlas Copco SF2FF Air Compressor & Air Cylinder This was removed from a university lab where it  (more)was surplus to requirements. The unit has been professionally serviced and is in good working order. A full report is available on request. It is in good cosmetic condition with minor marks from use.

The Envirco MAC 10 fan filter unit, was the first (FFU) to combine low sound, low watts and a low pr (more)ofile. Measuring only 51 dBA, the MAC 10 Original Standard (600 mm x 1210 mm) provides one of the lowest sound levels of any FFU in the industry. Running at only 310 watts at 90 fpm, the unit uses less energy than traditional FFUs, lowering operating costs. The MAC 10 Original maintains a low profile, measuring less than 330 mm. MAC 10 Original comes standard with the filter integral with the unit housing, requiring the unit to be removed from the ceiling grid to replace the filter. The RSR unit has the filter sealed to the unit using the knife edge/gel seal construction, allowing the filter to be replaced from the roomside. The RSRE unit has the added feature of allowing the motor blower and filter to be replaced from the roomside. Low sound, low watts, low profile, and low operating costs. Three speed switch features low, medium, and high settings; standard on all 2 ft x 4 ft units Solid state speed controller standard on 2 ft x 2 ft, 2 ft x 3 ft, and all RSR units. Forward-curved centrifugal fan. High Efficiency Particulate Air (HEPA) UL900 Filter: 99.99% efficient at 0.3 Micron. Snap-in prefilter allows for easy replacement and maintenance. Walkable Plenum (excluding prefilter), rated at 250 lbs. Mill finished aluminum exterior. Tested to IEST recommended standards. Caution this is a 110 Volt instrument.

The offered instrument / system is fully functional tested and ready to use. FURTHER DETAILS TO FOLL (more)OW

Temperature range: 2°C to 20°C Content: 104 L Dimensions (WxDxH): 595 x 640 x 1001 mm Weight: 43 kg  (more)Explosion proof

This Sutter Instrument Co. Model P-87 Flaming / Brown Micropipette Puller was removed from a univers (more)ity lab where it was surplus to requirements. The unit powers up and is in reasonably good cosmetic condition, however, it does have a small Crack on its right side. It was tested with a digital thermometer (not included), and the filament does heat up.

The H315 waterproof scale Made to work in high humidity conditions and even direct contact with wate (more)r. Designed for precision measurements, making it used in situations where weighing readability is crucial. The power of steel The use of stainless steel for the construction guarantees you a long life for the balance. It is not afraid of contact with moist objects or accidental splashes. The robustness and strength of the design of the platform scales makes it possible to weigh large objects, such as pallets of goods. The stable platform is resistant to vibration, which is important when weighing large objects. Not just weighing But also parts counting, percent weighing, animal weighing and peak hold. The power of H315’s working mods. Do you require fast and repeatable weight measurement under difficult conditions? The H315 scale is made for that! It has been with us for years, and will stay for a long time to come The LCD display has accompanied us for long years. During this time it has proven its reliability. It guarantees the readability of the result from many angles and is energy efficient. Inner power No access to mains power? Power failure? No problem. Thanks to its internal rechargeable battery, the H315 scale allows many hours of operation without mains power (up to 7 hours). Battery power supply is available at an extra charge. As standard, the scale is equipped with a RS232 cable, to which you can connect most of the accessories from our range.

Scilogex HP380-Pro LCD Digital HotplateThe Scilogex HP380-Pro LCD Digital Hotplate is a very economi (more)cally priced and ideal for accurate heating applications below 380C. The HP380-Pro LCD features an easy to read backlit LCD display, ceramic plate for chemical resistance, and electronic speed control for constant speed even during changes in load. Click Here to View Product Video INCLUDED: The Scilogex HP380-Pro LCD Digital Hotplate includes: - Power Cord - Operator's Guide - Manufacturer's Documentation - 2 Year Manufacturer's Warranty