BugLab BE2100 Biomass Sensor

This was removed from a university lab where it was surplus to requirements. The units have not been (more) tested as we do not have the correct PSU. The units are in good cosmetic condition with minor marks from use. Included are; 1x GE Ready to Process CBCU unit 1x Ready to Process Pump 25 w/ Pumpheads 2x Pumpheads:114DV OEM Pumpheads•Prod No 113.5000.R33•Ser no. 66056-3

This Applikon My-Control Z310210011 Bioreactor Controller was removed from a university lab where it (more) was surplus to requirements. The unit powers up but we were unable to test it further at our facility. It is in good cosmetic condition with marks from use.

HyClone 50L Single-Use Bioreactor This was removed from a university lab where it was surplus to re (more)quirements. The unit powers up and is in good cosmetic condition with minor marks from use.

This HyClone 250L Single-Use Bioreactor SV50172.02 was removed from a university lab where it was su (more)rplus to requirements. The unit powers up and is in good cosmetic condition with marks from use. It comes with a 32A plug but has an adaptor with a standard plug. It also comes with 3 x Mixers & some other accessories.

Phenometrics enable scientists to study algae under the same conditions found outdoors in the ponds, (more) but in the much more efficient confines of the laboratory. Each computer-controlled PBR uses breakthrough technology to re-create the environmental conditions such as temperature, light intensity, and CO2. Choose from pre-programmed experiments, or quickly and easily design your own, with the growth variables that are most important to you. Many researchers use the PBR to set specific parameters to maintain consistency between experiments. Most importantly, the PBR enables reproducibility, a key factor in algae research experiments. The PBR saves time and money while producing better results. Each PBR is also a measurement instrument, measuring growth rates, pH, and other factors in the algae reactor vessel, which are displayed on the computer monitor in a graph or data display. It is customizable to accommodate various probes and sensors that monitor algae culture and growth metrics. 3000 μ-Einstein LED specially designed lighting system with conical vessel that accurately mimics BOTH raceway or production tube bioreactors (controllable from 0- 3000 in steps of 25 μ-Einsteins. Fully programmable Diurnal Cycles; you set the length of sunlight day, and also the hour of peak sunlight. Fully programmable heating and cooling, linkable to the diurnal cycle; you can independently set the hour of peak heating (if different from peak sunlight). Active cooling and heating, from 5 – 50°C Algal Command Software provides for complete, simultaneous, integrated control of up to 256 bioreactors from a single computer, with collation of all data. All the reactors are linked together via Ethernet Hub. CO2 programmable and controlled from Algal Command. Mixing through active magnetic stirring and/or gas sparging. Active sparging of up to two gasses Temperature measurement True Turbidostatic measurement Field-configurable, fully autoclavable, low cost durable polycarbonate reactor vessel The reactor vessel can have as many inlets and outlets as you require 100% (+/- 10%) directly-proportional (by volume) up-scale to pond, raceway, or indoor reactor pH measured and controlled by Algal Command Custom-engineered Turbidostatic Pump allows for true turbidistatic operation; fully programmable and computer-controlled. System contains 4 reactors and pumps with laptop Culture vessel volume: 700ml Working volume: 150 – 600ml Light intensity: Variable up to full ocean sunlight at equator (>3000 mmol photons m-2 s-1) in steps of 25 Temperature control: Active cooling and heating Culture temperature range: 10 – 50°C Diurnal + heating and cooling cycles: Fully programmable and independant Ability to control and measure pH: 0 – 14, may be controlled automaticly using CO2 gas Mixing: Magnetic stirrer Gas control: Computerized, CO2 or other as required Groth rate measurement: Continuous, via turbidistat Sterilization: Entire reactor vessel assembly, including culture medium, may be autoclaved on the “Liquid” cycle Turbidistatic pump: True turbidistatic operation, fully programmable from groth fase Dimensions (HxWxD): 482 x 241 x 318 mm Weight: 7kg

Selecta Agimatic N hot plate stirrer of 10 L capacity. 60-1600 rpm. Temperature range: from 50ºC to  (more)350ºC. 14.5 cm diameter stainless steel plate. Analog speed and heat control from 0 to 100%. Indicators with light. Selecta Agimatic N hot plate stirrer is a compact and efficient device that can be easily placed on a laboratory table. With its 10 liter capacity, it is ideal for heating liquids in a uniform and controlled manner in research and experimental environments. 50Hz 220 V 3A 306 W

Hermle 2 x 250ml insert for Z496-1000-RBUK 2/pk The Hermle 2 x 250ml insert for Z496-1000-RBUK 2/pk  (more)is a specially designed accessory for use with the Hermle Z496-1000-RBUK rectangular buckets. This insert comes in a pack of 2 and is capable of accommodating tubes with a maximum diameter of 62mm and length of 137mm. With a maximum capacity of 2 x 250ml per adapter, this insert allows for efficient processing of large sample volumes. The compatibility with Hermle Z496-1000-RBUK rectangular buckets makes this insert a versatile addition to any laboratory looking to improve their sample processing workflow. The use of this insert ensures that tubes are securely held in place during centrifugation, preventing any sample loss or contamination. INCLUDED: The Hermle 2 x 250ml insert for Z496-1000-RBUK 2/pk includes: - Set of 2 Adapters - Manufacturer's Documentation - 2 Year Manufacturer's Warranty

The Bio Data Platelet PAP 4-C Aggregation Profiler is a four channel Platelet Aggregation Profiler w (more)ith four test modes are available: Chromogenic Assays- von Willebrand Assay (Ristocetin Co-factor)- Platelet Aggregation and Leukocyte Aggregation. The PAP-4C may also be used for the evaluation and confirmation of Heparin Induced Thrombocytopenia (HIT). Four channels allow four tests to be run simultaneously and independently Chromogenic Assay Von Willebrand Assay (Ristocetin Cofactor) Platelet Aggregation Leukocyte Aggregation Heparin Induced Platelet Aggregation (HIPA) for Heparin-Induced Thrombocytopenia (HIT) Dimensions (h x w x d): 220mm x 515mm x 565mm 220V / 50-60Hz / 300W

The offered instrument / system is fully functional tested and ready to use. FURTHER DETAILS TO FOLL (more)OW

The offered instrument / system is fully functional tested and ready to use. FURTHER DETAILS TO FOLL (more)OW