Gilson VERITY 1920 Mass Spectrometer System

Bruker MicrOTOF II Time-Of-Flight Mass Spectrometer This item was removed from a university laborato (more)ry where it was surplus to requirements. The spectrometer powers on and is in good cosmetic condition, with a few very small marks on the outer casing. A loss of MS signal was reported to Bruker in August 2022. After replacing the glass capillary, the issue was temporarily resolved but re-occurred in October 2022. Bruker advised replacing the MS source door and the roughing pump. Due to the required MS source door and roughing pump, this system is not functional and is listed as Spares/Repair. Includes: - 1 x new Bruker 8236619 maintenance kit (air filter, hydrocarbon trap, oil backing pump oil, exhaust filter cartridge, and filter mat) - 4 x data cables - 4 x U-bend stainless steel 1/2" pipes - 1 x air 90˚ elbow connector 1" Serial No.: 823175010435

FURTHER DETAILS TO FOLLOW

Applied Biosystems NanoSpray II  MDS SCIEX  Assy no. 1014665 This was removed from a univ (more)ersity lab where it was surplus to requirements. The unit is in good cosmetic condition but has not been tested. Applied Biosystems NanoSpray IIMDS SCIEXAssy no. 1014665SN - 0001042805

2x Waters Nano Nano LockSpray Exact Mass Ionization Sources  Code No. M951748DC1 These were rem (more)oved from a university lab where they were surplus to requirements. They are in good cosmetic condition but have marks from use. The cables have been cut so they could not be tested.

Micromass Waters Q-TOF Premier Mass Spectrometer This system was removed from a university lab where (more) it was surplus to requirements. The spectrometer is in excellent cosmetic condition, though the right-hand side panel is missing. It powers on, but the PC repeatedly displays a "VxLd 1.2" message during boot-up and does not progress further. The previous owner reported a failed HV board. Due to the failed HV board, this system is listed as Spares/Repair. The system includes the following: - Micromass Waters Q-TOF Premier Mass Spectrometer - Serial No.: HAA009 - Enlight PC - Serial No.: ECDG0406050406 - Dell Monitor - Serial No.: CN-ODC323-71618-64A-GNPO - HP Keyboard - Model No.: KB-0316 - Serial No.: BATHA0KVBZK - 1 x Spare spray source assembly (Code No.: M951593CC1, Serial No.: 33/015) - 1 x Spare spray source assembly with Watec W85BC camera (Serial No.: 63623) - 1 x Spare outer stage assembly

Sequenom Agena MassARRAY Analyzer 4 System RS1000, PHX-1 & Accessories This was removed from a  (more)university lab where it was surplus to requirements. The system powers up and everything communicates but we were unable to test it further at our facility. The touchscreen on the nanodispense does not work, but we have replaced it with a monitor, mouse and keyboard. There is also a complete peripheral setup provided for the inbuilt PC in the PHX-1 system. Included in the system are; Sequenom Agena MassARRAY Analyzer 4 PHX-1Model: PHX-1Serial#: PX10060104 Sequenom Agena MassARRAY Nanodispenser RS1000Model: RS1000Serial#: 10P0413RS-01 The system also includes the following: Windows XP Software DiscNI Vision Deployment Engine for One UserMassARRAY Nanodispenser RS-1000 User's Guide v1.2.1WebPAM Software DiscFastTrak TX2300/TX4300 Quick Start GuideVarious Replacement parts (shown at end of slide)Various Plates for plate reader.

SCALES SUITABLE FOR EVERY USE The Navigator Series is perfect for general weighing applications in l (more)aboratory, industrial, education, retail, commercial, manufacturing, food and portioning environments. A powerful, rugged and multifunctional scale capable of handling a wide range of weighing applications with features such as fast stabilization time, overload protection four times its rated capacity and easy operation. - Excellent value for money - One-second stabilization to improve efficiency, productivity and throughput - Overload protection system, capable of withstanding loads up to four times higher than the nominal capacity: protect the scale from improper use. Applications Weighing: Determines the weight of the items on the pan in the selected unit of measure. Piece Counting: Count the number of pieces on the pan using a uniform weight. Percent Weighing: Measures the weight of a sample displayed as a percentage of a pre-set reference weight. Checkweighing: Compares the weight of a sample against the set targets. Other standard features and equipment ABS construction, stainless steel weighing pan, transport lock, menu switch and safety lock for adjustment, non-slip and adjustable feet, bubble level, mechanical and software overload/underload protection, indicator stability, low battery indicator, auto power off, user selectable print options, user selectable communication settings. MODELS AVAILABLE Applications Weighing, Parts Counting, Percent Weighing, Checkweighing Display Liquid Crystal Display (LCD) with backlight Operation AC adapter (included) or 4 C batteries (not included) Communication RS232, USB, or Ethernet (available as accessories) Construction ABS housing, stainless steel pan, transportation lock, slip-resistant and adjustable feet, leveling bubble Design Features Menu and calibration lock switch, mechanical and software overload/underload protection, stability indicator, low battery indicator, auto shut-off, user-selectable print options, user-selectable communication settings SUITABLE FOR ANY FIELD AND USE EDUCATIONAL: valuable overload protection system. Additionally, the portability of the Navigator balance makes it ideal for field experiments. LABORATORY: simple to clean, precise and easy to use in the laboratory. Ideal for laboratory applications such as formulation, quality inspection, testing and experimentation. INDUSTRY: Robustness, speed and accuracy, it is ideal to use in medium-light industrial applications such as paint and ink mixing, packaging, sampling and piece counting. SALES, TRADE, AND MANUFACTURING: Rugged, Portable, and Reliable. Ideal for use in shipping and receiving, retail or warehouse environments. Battery operation and counting and checkweighing modes expand the possibilities of use in hobby, inventory management, inspection and quality control. FOOD AND PORTIONING: hygiene, duration and reduced maintenance. Ideal for portioning and in pre-packaging. Units of measure such as kg, g, lb, oz, lb:oz and checkweighing and percentage checkweighing modes enhance their utility at the counter, in prep and in the kitchen.

Fisher Scientific Isotemp 3016S Recirculating Water Chiller and Heating Unit This item was removed f (more)rom a university where it was surplus to requirement. The unit powers up and is in good working order (thermometer not included). Specifications: - Temperature range -20 to +150˚C - Reservoir volume 6 litres - Pumping capacity 12 litres per minute

The Profinia protein purification system is an automated chromatography system that provides a simpl (more)e solution for the purification and desalting of milligram amounts of affinity-tagged proteins. Flow rate range: 0.2 – 20 ml/min Maximum backpressure: 3.4 bar UV absorbance wavelength: 280 nm Conductivity monitor range: 0 – 500 ms/cm Pressure: Sensor monitors system pressure Solvent compatibility: All commonly used chromatographic solvents Dimensions (WxDxH): 580 x 330 x 670 mm

Ohaus Guardian 5000 e-G52HP07C-K1 Hotplate, 120V Temperature Range Ambient + 5°C to 550°C Plate Size (more) 7 in x 7 in (18 cm x 18 cm) Temp. Stability +/-1% Plate, below 100°C +/-1°C and +/-0.5% Probe, below 100°C +/-0.5°C Features - Heats up to 550°C for versatile laboratory applications - 7 x 7 inch ceramic plate provides even heat distribution - Temperature calibration with 3 plate/3 probe accuracy - Bright LCD display ensures easy monitoring of settings - Offers Ethernet, USB, and RS232 connectivity for data logging - CE and TUV certified for reliable safety standards - Includes Pt1000 temperature probe and holder for precise control - Adjustable timer from 1 minute to 99 hours, 59 minutes The Ohaus Guardian 5000 e-G52HP07C-K1 Hotplate, 120V, is designed to provide precise, reliable heating for a range of laboratory applications. Equipped with a durable 7 x 7-inch ceramic plate, this model evenly heats up to 550°C, ideal for tasks requiring stable and consistent temperature control. The unit’s advanced calibration capabilities ensure accuracy with 3-point plate and probe calibration, enhancing precision for temperature-sensitive procedures. This hotplate features a high-contrast LCD display for clear visibility of temperature settings and includes Ethernet, USB, and RS232 connectivity options, enabling easy data logging and remote control. With CE and TUV safety certifications, the Guardian 5000 also comes with a Pt1000 temperature probe and holder, offering accurate and adaptable heating solutions for professional lab environments. INCLUDED: The Ohaus Guardian 5000 e-G52HP07C-K1 Hotplate, 120V includes: - 30500590 Temperature Probe - 30973298 Temperature Probe Holder - Power Cord - Operator's Manual - Manufacturer's Documentation - 2 Year Manufacturer's Warranty

Multifunctional scales TMX H is designed to fast and precise determination of mass in industrial con (more)ditions. TMX H Multifunctional scales TMX H comprises terminal PUE 5 and a weighing platform. Labelling system series TMX H is used to print labels for marking weighted goods e.g. in the process of packing. The program can generate standard labels for single goods. Functionality of the software: a function of weight control (weighing control + / -), previewing weighments carried out on weighing terminal as a table of weighments, simplified reporting module allowing the report to be generated, creation of label templates from labels in weighing terminal, identification of goods by using the code EAN-13 and EAN-128, quick search using the range of barcode scanner, the availability of databases: the operators, products, clients, warehouses, tares (packages), etc. The application enables measurements execution and their record into a local database or on the server. Networked terminals allow transmission of the measurements to the parent database installed on the server. The ability to work with a computer program E2R SYSTEM. Terminal types: PUE 5.15R, PUE 5.19R – resistive touch screen technology. Protection class IP68. High resistance to moisture and dust. In comparison to remaining models, limited brightness and lower resistance to shocks and scratches. Possibility of operation using gloves preventing scratches (latex, material). PUE 5.15IR, PUE 5.19IR – infrared touch screen technology. Protection class IP68. Very high brightness and readability level. High resistance to moisture and dust. High mechanical resistance, possibility of operation using gloves (made of latex, material or even steel chain). PUE 5.15C, PUE 5.19C – capacitive touch screen technology. Protection class IP68. High brightness and readability level. High resistance to moisture and dust, good mechanical resistance. Absolute precision of touch detection, sensing multiple points of touch (multi-touch).

E2-class mass standards represent an exceptional standard of precision in mass measurement. Classed  (more)as E2 metrology class, they are characterized not only by their high accuracy, but also by their versatility for use in laboratories, industry or scientific research. Versatility of Applications Varied Standards: The set consists of 12 flat polygonal sheets and 8 cylindrical standards, providing a wide range of calibration options. High-Quality Accessories: The set also includes a brush and tweezers, facilitating precise and safe cleaning and handling of the standards. Elegant Packaging: The standards are delivered in an elegant wooden box, ensuring their safe storage and transportation. *The mg unit mass standards are flat polygonal sheets. **The 1 mg, 2 mg and 5 mg mass standards are made of aluminum.