KNF IP65 FEM 1.02 TT.18RCP Liquid Pump

Laboport SD N 860.3 FT.40.18 is a two-stage pump with an integrated “self-drying” system for automat (more)ic condensate drain. The “SD” series is widely used in laboratories, especially when the vapors are humid and a clean and ecological vacuum is required. Typical applications are: vacuum ovens (for drying chemicals, drying biological samples, heat treatments), autoclaves for sterilizing instruments, containers, filters and textiles. Thanks to the use of anti-corrosion materials, it is possible to vacuum even corrosive products. The heart of the pump is the diaphragm with differentiated structure in PTFE, optimized to guarantee high performance with reduced dimensions and at the same time, long life even in heavy applications. When the humid gases are sucked in, it can happen that condensation forms in the pump head: consequently the performance decreases, considerably increasing the emptying time. To eliminate condensation, the 'drying system' then opens a solenoid valve that allows ambient air to enter the heads. Once the condensation has been eliminated, the solenoid valve closes and the pump sucks from the stove in full capacity. Over time, condensation could form again and then the cycle is repeated. The time interval between one cycle and the next can be adjusted as desired, as well as the duration of the air injection. Technical features Flow rate (max.) 60 l / min Final vacuum (max.) 4 mbar (abs.) Pressure (max.) 1 bar (rel.) Fluid temperature allowed at 5-40°C FFPM valve material PTFE coated diaphragm material Pump head material PTFE Applications Rotary evaporation Centrifugal concentration Distillation Vacuum oven Qualitative characteristics Clean operation, 100% oil-free Corrosion resistant PTFE / FFPM flow path Ideal for extremely aggressive / corrosive gases and vapors Compact, silent and reliable The self-drying system removes condensation without altering the vacuum level Maintenance free Download the data sheet for further information and accessories. NOT SURE WHICH VACUUM PUMP YOU NEED? Try following our guide to KNF pumps: VACUUM PUMPS FOR THE LABORATORY Or download the KNF guide: THE IDEAL DIAPHRAGM PUMP FOR EVERY APPLICATION

The offered instrument / system is fully functional tested and ready to use. FURTHER DETAILS TO FOLL (more)OW

Edwards E2M-2 2 Two Stage high Vacuum Pump This was removed from a university lab where it was surpl (more)us to requirements. The unit powers up and is in working order. It is in reasonably good cosmetic condition but has marks from use.

This Gallenkamp Digital Flame Analyser FGA-350-L was removed from a university lab where it was surp (more)lus to requirements. The system powers up and is in good cosmetic condition with minor marks from use. We were able to get it to produce a spark. The lab confirmed that it was working prior to removal. With it is; 1 x Lafert air compressor pump:Model LM 63/4The unit powers up but has not been tested further.

LAUDA Proline immersion thermostat The LAUDA Proline bridge thermostats with vario flex pump are exc (more)ellent for thermostating in any tank. The PB models have a pressure / suction pump and are used in tanks of 200 mm. While the PBDs are equipped with pumps with more powerful pressure and used in tanks of 320 mm deep. Also available are a telescopic rod for tubs with a width of 310 to 550 mm, an ergonomic handle and attachments for side pumps. The LAUDA Proline bridge thermostats are available with two different control panels. The Master version (PB, PBD) is designed for all applications where the parameters are not changed very often. Models with the removable Command operating unit (PB C; PBD C) offer a graphic LCD screen for high ease of use and optimum functionality. Notable features - PowerAdapt system for optimal adaptation of the max. Heat output. without interfering with the mains power supply - Low level protection and adjustable overtemperature protection with audible alarm. Levels measured with float Accessories included Fittings for pump connection, telescopic rod Specific characteristics of the Proline PB C model - For tanks of 200 mm deep - State-of-the-art Command control panel, removable, for remote use; LCD display with the most advanced feature set in the LAUDA range - Tank volume max. 80 L - Water-cooled temperature range from 20°C to 300°C - Operating temperature range from -30°C to 300°C - Pump connectors M16 x 1 - Fitting 13 Ø

Tecan Genios Pro Multifunction Microplate Reader: The Tecan Genios Pro is a fully automatic, compute (more)r controlled Fluorescence. Luminescence and Absorbance instrument for measuring samples in a microplate. The instrument fulfills the requirements for numerous fluorescence, absorbance and luminescence applications in research and routine investigations. The filters are arranged in filter slides; four excitation filters and four emission filters respectively can be installed in the slides. Handles 6, 24, 96 and 384 well plates. Spectral range 360-700nm for fluorescence. 230-900nm absorbance spectral range. Sensitivity ≤1.5 picogram fluorescein on each well or ≤4 fmol well. The emission signal is measured by a highly sensitive PMT. Different detection techniques with one instrument change of measurement directions (top / bottom) by PC software. Thermal incubation at +5º C to + 40º C. Dual optical channels allow measurements from above or below the plate by mouse-click. Light to and from the samples is focused by a lens and high quality filters are easily accessible from the front of the instrument. Each filter slide can hold up to four filters. Orbital shaking and temperature control are standard. Plate formats: 6 to 384 well plates Absorbance Range: 230-999nm Temperature control: Ambient + 5 °C to 42 °C Shaking: Linear or orbital, 3 velocities Fluorescence Intensity Wavelength range: Excitation: 230 – 850 nm, emission: 280 – 850 nm Bandwidth: Adjustable from 2.5 nm – 10 nm below 280 nm, 5 nm – 20 nm above 280 nm Wavelength accuracy: ± 1 nm Wavelength precision: ± 1 nm Sensitivity (top reading – 384 well plate): 0.2 fmol/well Sensitivity (bottom reading – 384 well plate): 0.6 fmol/well Time Resolved Fluorescence Sensitivity (384 well plate): 60 amol/well Precision (384 well plate): 3 mP standard deviation Fluorescence Polarization Wavelength Range: 275-750nm Absorbance (96 well) Wavelength range: 230 – 999 nm Wavelength accuracy (492nm): ±/- 1% and ±/- 0.010 OD OD Wavelength precision (492nm): ±/- 10,5% and ±/- 0.005 OD OD Measurement range: 0 – 4 OD Glow Luminescence Type: Chemi or Bioluminescence Wavelength readings: 400-700nm

LEEC Research CO2 Incubator Model-GA2000 This item was removed from a university where it was surplu (more)s to requirement. The unit powers up and is in good working order (thermometer not included). It is in reasonably good cosmetic condition.

This Beckman Centrifuge Model - J2-21 Cat no. 341737 with JA-10 10000rpm Rotor was removed from (more) a university lab where it was surplus to requirements. The centrifuge has been professionally serviced and is in full working order. There is a full report available on request. Included are manuals for the centrifuge & rotor along with some O-Rings for the JA-10. Rotor Type - JA-10SN - E 209946 X 500ml Slots

Do you need a balance that not only determines weight with impressive accuracy, but also performs a  (more)digital audit, responds to your voice commands and sends you light messages? If so, learn about the functionality of the ELLIPSIS series of balances: Digital Weighing Auditor Ensures that your balance is ready for use. It enables air buoyancy compensation in real-time. What is more, it informs about the need for a balance inspection or a periodic audit of the balance’s accuracy and sensitivity. 10-Inch Display Bigger screen – 10’’ – means more information in one place. On the new ELLIPSIS terminal, you will see up to 3 screens, widgets, graphs, statuses, notes, handy measurement history. Uncompromising User Verification For the first time ever, the balance will verify the user using a password, RFID card, fingerprint reader, facial recognition mechanism, or any combination of these. Ambient Light – An Innovative Way for the Balance to Communicate With the User The light colour will tell you about status, process results, procedures, or alerts. Hotspot Use the balance on any device connected to it. This can be a smartphone, tablet, or computer. RFID ELLIPSIS works with RFID tags* that can be used to tag your products or formulation ingredients in the database. They can also be used to identify a user. Live Note – Note Down Your Conclusions It’s the first time you can add a voice memo to a measurement series or procedure report. If you prefer to write it down, ELLIPSIS allows you to add a text note. Handy Library This is where a series of recent measurements or a report ready for digital signature, according to 21 CFR Part 11, can be found. Widgets Prepared to display what you need most at any given moment. Smart Min Weight The balance displays whether the value of the weight you want to weigh is below or above the minimum weight threshold. 21 CFR Part 11 Do you work in the pharmaceutical industry? Do you need a digital signature? We are offering the laboratory balance which as a standalone fully meets the requirements of 21 CFR Part 11/ EU GMP Annex 11. - Full data security - Electronic signatures - Validations - Electronic records - Audit trails Modbus TCP/IP is one of the most popular communication protocols in industrial automation. Implementing it in the 5Y balances and CY10 scales makes the devices of this series friendly to automation integrators. A balance or scale in a Modbus system is a slave device and performs tasks specified by the master device which is most often a PLC. Protocol Modbus TCP/IP in the 5Y balances and C10 scales enables, among other things, the realization of mass readout, zeroing and tare functions of the device, as well as tare settings and MIN and MAX thresholds. Two-point adjustment Adjacency, which takes place at two measurement points instead of one, improves measurement precision over the full weighing range. And what does this mean for you? More accurate measurement. Under-pan weighing Weighing instruments purchased after 15th February 2023 will allow under-pan weighing at any time after the purchase. All you need to do is just to order a dedicated hook. * RFID ISO/IEC 14443 Type A, 13.56 MHz