Agilent 700 series ICP-OES system (G8460A)

The Frontier 5306 minimizes noise and interruptions in the laboratory: low input voltage power, sile (more)nt brushless motor and a rubber base that absorbs vibrations. Operator safety: rotor imbalance sensor and two safety switches that immediately stop the rotors if the lid remains open during use. Unprecedented ease of use: just place the sample in the centrifuge, close the lid and the centrifuge will start spinning without pressing any buttons. Operation AC power (included) Structure Silent brushless motor, small footprint Construction features Easy to install design Technical features Speed ​​range: 0 rpm – 6.000 rpm Maximum relative centrifugal force: 2.000 g Maximum flow rate (rotor): 8 x 1,5/2,0 ml Program memories: 0 Acceleration gear: 1 Deceleration gear: 2 Lid lock: mechanic Noise level: ≤60 ± 2 dB (A) Rotor Compatibility: Angled 8 x 1.5 / 2.0ml; Angled 4 x 8 PCR strips Execution time: continuous Safety certification: CE; FCC; TUV The Ohaus Frontier 5306 minimizes noise and interruptions in the lab: low input voltage power, a quiet brushless motor, and a vibration-absorbing rubber base. Operator safety: rotor imbalance sensor and two safety switches that stop the rotors immediately if the lid is left open during use. Unprecedented ease of use: just place the sample in the centrifuge, close the lid and the centrifuge will start spinning without the need to press any buttons. The KIT includes two rotors, described below. Maximum relative centrifugal force (x g) at 2,560 g; top speed at 6,000 rpm; tube diameter without adapter 12mm / 2.0ml, 1.5ml; outer/inner radius 45 mm. Maximum relative centrifugal force (x g) at 2,260 g; top speed at 6,000 rpm; tube diameter without adapter 12mm / 2.0ml, 1.5ml; outer/inner radius 32 mm. TECHNICAL FEATURES Speed ​​range: 0rpm – 6,000rpm. Maximum relative centrifugal force: 2,000 g. Maximum flow rate (rotor): 8 x 1.5/2.0ml. Program memories: 0. Rotor Pack: 8 x 1.5ml/2.0ml Angled Rotor; angled rotor 4 x 8 PCR strips. Accelerator gear: 1. Deceleration gear: 2. Screen (2): without display. Lid lock: mechanical. Net weight: 1.1kg. Noise level: ≤60 ±2 dB(A). Rotor Compatibility: Angled 8 x 1.5/2.0ml; angled 4 x 8 PCR strips. Rotor recognition method: not applicable. Runtime: Continuous. Safety Certification: CE; FCC; TUV.

Film formats: All formats (minimum dimensions 90 x 150 mm)

Beckman Centrifuge Rotor SW-28 28,000rpm This was removed from a university lab where it was surplu (more)s to requirements. It is in good cosmetic condition with minor marks. Beckman SW-28 28,000 rpm Serial No. 05U 10874Six Beckman swing buckets SW 28 38.5ml

Guardian 2000 Ohaus - Economical, for general stirring and heating Ideal for education and laborator (more)ies requiring fast, economical daily heating and reliable stirring up to 15 litres. All three models offer a simple knob control to easily adjust the heating and/or stirring functions. The heavy-duty construction includes an optional support rod holder. Stir models include PTFE coated stir bars. ★ Safe heating up to 500°C and stirring up to 15L with an easy to use knob control ★ Rugged metal housing with spill resistant design. The smooth, chemical-resistant ceramic soleplate is easy to clean ★ Safety is of the utmost importance: the indicator light turns on when the plate exceeds 40°C, ensuring operator safety during all heating applications. Applications Boiling liquids, preparation of samples and stock solutions, buffers and dissolution reagents, preparation of media, concentration of samples Display Light indicator for hot plate, green light when unit is heating and/or stirring Functionality Simple knob control, agitation up to 1600 rpm, temperature up to 500°C (or 380°C for round plate model) power cord (included), agitation models include PTFE coated stir bar Construction Heavy duty metal housing, PET front panel, control knobs, ON/OFF switch to disconnect heater, integrated support rod holder, easy to clean ceramic coated resin, ceramic or stainless steel tops Clean and simple control panel. For education, it is designed for maximum safety in the classroom. Easy Swtich on/off for all models. Fast and secure. THE MODELS AVAILABLE: The Guardian 2000 is made up of 9 models. Models with hotplate only, with magnetic stirring only or with both. In turn, they can be chosen for the size of the plate: 102x102mm; 174x174mm; Ø135mm.

Manufacturer: Thermo Scientific / Revco Model: UGL-2320V Laboratory Freezer -20°C P/N: UGL2320V Desc (more)ription: Simplify operation and increase accuracy with the microprocessor control of Thermo Scientific Revco High-Performance Lab Freezers. Our Revco -30°C and -20°C high-performance freezers are designed for medical and scientific applications such as storage of reagents, pharmaceuticals, biologicals or other commonly used laboratory materials. Models offer cabinet sizes to fit a variety of space needs and storage volume requirements. Key Features: - Temperature factory-preset at -20° or -30°C. - Capacities from 4.9 to 51.1 cu. ft. (139 to 1447L). - Icon-based controls and displays. - Large, easy-to-read digital display shows temperature within 1°C. - Graphic thermometer is steady green when temperature is normal, flashes top bar for overtemperature, flashes bulb for undertemperature. Microprocessor Control: - Audible/visual warnings for overtemperature, undertemperature, or power failure. - Key-operated OFF/ON/ALARM ON master switch for setpoint security. - Push-button alarm test. - Remote alarm contacts. - Alarm silence, ringback, and auto reset. - Controller battery backup system. Construction: - Scratch-resistant cold-rolled steel interior and exterior finishes. - High-density, 2? thick (5.1cm) CFC-free urethane foam insulation protects against ambient temperature fluctuations. - CFC-free, HFC-blend refrigerant. - Single-door models are hinged on right. - Full-length door handle and key lock. - Doors self-close and lock open at 90°. - Adjustable epoxy-coated wire shelves. - 1? (2.5cm) dia. access port with plug on undercounter model. -20°C Freezers Features: Suitable for applications in which slight intermittent coil warming during an automatic defrost cycle is not desired (such as enzyme storage). Gravity convection air system for maximum stability without a blower or fan. Manual defrost. Specifications: Capacity: 659 L Dimensions (LxWxH) Exterior: 94.5 x 71.1 x 201.2cm Dimensions (DxWxH) Interior: 73.7 x 61 x 147.3 cm Temperature Range: -20°C Type: High-Performance Freezer Mains: 230V 50Hz Doors: Single, Solid   Refrigerant CFC-free 4 Shipping Weight: 193kg Temperature Control: Microprocessor Cabinet Type: Upright Defrost: Manual Items delivered: - Thermo Scientific / Revco UGL-2320V Laboratory Freezer -20°C - Shelves - Instruction Manual - Power Cord The laboratory freezer is good cosmetic as well as technical condition.

The HX5.EX scale is a modern weighing instrument assuring fast and reliable measurement in hazardous (more) areas classified as zones 1/21 and 2/22. To ensure precision and excellent measurement repeatability, high quality electronic components are used. The weighing platforms offered in wide range of dimensions and maximum capacities, this combined with excellent metrological parameters enables easy selection of an instrument that meets the most demanding requirements. Standard version of the scale is equipped with 2 serial, intrinsically safe RS232 communication interfaces, and with one RS485 interface. They facilitate cooperation with equipment intended for operation in hazardous areas. Possibility to add digital inputs/outputs extends the range of instruments compatible with the indicator by automatic elements compliant with ATEX directive. More demanding customers can use the IM01.EX module, installed in the safe area, which extends the available connectors by Ethernet, USB, 4-20mA/0- 10V analog outputs, Profibus DP and additional digital inputs/outputs. This enables cooperation with external devices: barcode scanners, printers, external displays, control buttons, light signalling towers, other controlling/signalling devices, systems for automatic process control and superior IT systems. Scale operation requires use of a dedicated PM01.EX power supply, which is not a standard scale component. To operate the scale, order a selected type of the dedicated intrinsically safe power supply. Power supply types: PM01.EX-1 - power supply for operation in ATEX area. Used when it is required to connect the power supply to voltage source placed in hazardous area. PM01.EX-2 - power supply for operation outside ATEX area. Used when power supply connection to voltage source is carried out outside hazardous area. Complex software enables carrying out many tasks connected with mass measurement, e.g. parts counting, checkweighing and statistics. The scales feature user-friendly graphic interface, which can be customized using widgets. This and the large colour display of high resolution guarantee easy and clear transmission of data on current process. Colour bar graph significantly influences performance by signalling whether the weighing result is within declared thresholds or not.

Turbomolecular vacuum pump Edwards EXT255H 24V. Pumping speed: 220 lit/sec. Inlet flange: ISO100. Ba (more)cking connection: KF25 Minimum size backing pump: 10CMH. Cooling: Water or Air. Edwards EXC 100 or EXC 120 Turbo Pump Controller is needed to operate the pump (excluded).

The offered instrument / system is fully functional tested and ready to use. FURTHER DETAILS TO FOLL (more)OW