Sanyo MCO-20AIC CO2 Incubator Lab Spares/Repairs NOTE - THIS IS A SPARES/REPAIRS ITEM

This Revco Habitat CO2 Water Jacketed Incubator Model no. RCO3500TWBB was removed from a univer (more)sity lab where it was surplus to requirements. The unit has been fully tested and recertified by a qualified service engineer. The report is available on request if you would like to see it. The unit has a water jacket that will require a top-up on installation. The unit will require 8-10 hours to stabilise once installed. It is in excellent cosmetic condition with some minor marks from use. 4 Shelves - 49.5 x 49.5cm Internal dimensions - D52 W50 H55cm

LMS 400NP Cooled Incubator This item was removed from a university where it was surplus to requireme (more)nt. The incubator is in excellent cosmetic condition and powers on.However, the compressor did not start up during testing, so the unit is unable to reach its minimum temperature of -10°C. Therefore, it is listed as Spares/Repair. Specifications: - Serial No.: 12425/17PP - Capacity: 450 litres - Internal dimensions: 64 x 55 x 118 cm (l x w x h) - Temperature range: -10°C to 50°C - 4 height adjustable shelves (56 x 60 cm) - Factory set auto defrost system

Memmert BM400 Incubator This item was removed from a university lab where it was surplus to require (more)ment. The unit powers up and is in good working order. It is in good cosmetic condition. Specifications: - Model: BM400 - Serial#: 891076

Temperature range: Ambient +5°C to 50°C Relative humidity: <90% at 37°C Humidity source: Water pan M (more)aterial: Stainless Steel Chamber material: Polished stainless steel Capacity: 184 L Interior dimensions (DxWxH): 508 x 541 x 681 mm Dimensions (LxWxH): 635 x 668 x 1003 mm Weight: 118 kg CO₂ module is defective and incubator is retrofitted to a normal incubator.

VELP FOC 225I Refrigerated Thermostat Incubator / Drying Oven Total volume: 225 litres FOC225I Usefu (more)l internal volume: 196 litres Temperature range: 3.0 to 50.0 ° C Internal temperature indicated by a display Temperature resolution: 0.1 ° C Electronic thermoregulation system: AUTO-TUNING 2 internal electrical outlets Number of shelves included: 4 Power: 350W Weight: 40 kg Dimension (WxHxD): 540x1300x560mm (21.6x23.2x23in) With internal glass port Continuous ventilation and the Auto-Tuning thermoregulation system ensure temperature uniformity throughout the chamber. The temperature can be set from 3 to 50 °C, the reading on the display refers to the actual internal temperature. The FOC 225I is equipped with two internal sockets controlled by an external switch

BINDER BD-115 incubator / oven with natural convection 100°C Model: BD115 Capacity: 115 liters Tempe (more)rature range: Room temperature plus 5 °C to 100 °C Inner glass door Integrated digital temperature display 2 shelves Cable passage: Ø 30 mm (on the left wall) Power supply: 230 V, Frequency: 50-60 Hz, Power: 400 W, Internal dimensions: 60 x 40 x 48 cm Overall dimensions: 83.5 x 75 x 70.5 cm Weight: 61 kg Tested at 37°C (temperature measured: 35.5°C)

This Synbiosis aCOLyte 3 Colony Counter was removed from a university lab where it was surplus to re (more)quirements. This unit powers up with a 12V DC power adapter (not included). The device runs through the 3 different start-up stages but has not been tested further. It is in good cosmetic condition with marks from use.

Jouan CR4-22 Benchtop Refrigerated Centrifuge With Swinging Bucket Rotor This item was removed from  (more)a university lab where it was surplus to requirements. The centrifuge powers on and is in fair cosmetic condition. The rotor did not reach the maximum RPM of 4750, stalling at 4100 RPM. It has been temperature tested. (Thermometer not included.) Due to the inability of reaching its max RPM, this centrifuge is listed as Spares/Repair. Includes: - Jouan bucket rotor - 4 x 85220020 buckets - 4 x swinging plates - 4 x bucket inserts for 50ml tubes - 4 x bucket inserts for 25ml tubes

Ohaus 30400193 Modular Combination Heat Block, 1.5 mL, 15 mL, and 50 mL Tubes The Ohaus 30400193 Mod (more)ular Combination Heat Block, 1.5 mL, 15 mL, and 50 mL Tubes is crafted from solid anodized aluminum to ensure durability and efficient heat transfer. This modular block is compatible with Ohaus HB Series Dry Block Heaters. INCLUDED: The Ohaus 30400193 Modular Combination Heat Block, 1.5 mL, 15 mL, and 50 mL Tubes includes: - Manufacturer's Documentation - 2 Year Manufacturer's Warranty

Temperature range: 4°C to 15°C Dimensions (HxWxD): 2050 x 710 x 815 mm Internal dimensions (HxWxD):  (more)1510 x 590 x 620 mm

Dimensions (WxHxD): 900 x 600 x 580 mm

The offered instrument / system is fully functional tested and ready to use. FURTHER DETAILS TO FOLL (more)OW