Cary 8454 UV-Vis Diode Array System

HOW DOES 'QUARANTINE' WORK? 1 - A fire breaks out inside the safety cabinet. 2 - The automatic syste (more)m overturns the shelves and slides the batteries stored in the cabinet into a tub. 3 - Inside the water tank the batteries are placed in a sort of quarantine which will not only definitively extinguish the fire but also exclude the possibility of self-combustion. ACCESSORIES Electrical sockets are not standard. Contact us for your custom configuration.

LITHIUMSAFE SAFETY CABINETS Certifications: EN 14470-1 EN 16121 The line of LITHIUMSAFE safety cabin (more)ets consists of innovative high quality products, built in Italy and specifically built for the safe storage of lithium batteries. These cabinets are designed according to current standards and can be equipped with numerous accessories for further levels of safety. CONSTRUCTION - Completely built in electro-galvanized steel sheet, cold pressed with removable external structure; thicknesses of 1/1.5/2 millimeters and painting with anti-acid epoxy powders and passage in a thermal tunnel at 200°C. - Special insulation for high temperatures (800°C) with high density 300 Kg/m3 calcium silicate and mineral fiber panels (Fibroceramic free) fixed with ceramic adhesives. - Fireproof melamine laminate panels with high resistance to even aggressive vapours. Certification according to EN 14470-1 and EN 16121 standards. CARATTERISTICHE - AUTOMATIC CLOSING of the door in the event of temperatures exceeding 47°C - LOCK AND LOCK OF THE DOORS WITH KEY - Certified automatic closing SYSTEM (70/100 °C) of the air inlet and outlet ducts, maintenance-free, placed on the back of the cabinet. - Ejection HOLE diam. 100mm. at the back of the wardrobe - Anti-spark hinge in natural iron with brass plug. - 1 shelf perforated at the base - 3 cm thermo expanding GASKET. (DIN 4102) - 'Earth' CLAMP to prevent electrostatic charges CHEMISAFE QUARANTINE SYSTEM Thanks to this patented system, in the event of a fire inside the safety cabinet, an automatic response will be activated to overturn the shelves, thus allowing the batteries to fall into a water tank located at the bottom. By immersion, the fire will be promptly extinguished and the potential risk of self-ignition will be effectively neutralised. Simple and very effective system! The cabinet is equipped with a water pump and algaecide. The QUARANTINE versions have only 3 shelves instead of the basic 4. Demonstration video of the QUARANTINE system.

These were removed from a university where it was surplus to requirements. The units power up but ha (more)ve not been tested further. There are warning errors due to no drives being inserted. The units are all in good cosmetic condition.

Tufvassons 3 Phase Autotransformer Lab This item was removed from a university where it was surplus  (more)to requirement. It is in good cosmetic condition and powers on, we are unable to test it further at our facility.

Orbit Marine Div AL-7100-SDU-MK2 Servo Driver Unit This was removed from a university lab where it w (more)as surplus to requirements. It is in good cosmetic condition but has not been tested at our facility.

P.A. Hilton Boyles Law Demonstrator This was removed from a university lab where it was surplus to r (more)equirements. It is in reasonably good cosmetic condition. This item does not power on, therefore sold as Spares or Repairs.

This Bio-Rad PDS-1000/He Biolistic Particle Delivery System was removed from a university lab where  (more)it was surplus to requirements. The system powers up but we were unable to test this further at our facility. It is in good cosmetic condition with marks from use throughout. Also included are the following:1x Circle Seal Control Solenoid3000 PSI 1x Busch PumpModel: KB 0010 D 100S/N: 01017631 1x Bio Rad PDS Voltage Converter1x USA Power Cable1x Australia/China Power Cable

Oxford Diffraction Xcalibur PX Ultra Crystal Diffraction X-ray Generator System This system was remo (more)ved from a university lab where it was surplus to requirements. The system is in very good cosmetic condition, but several units encountered issues during testing, and no PC or control software is included. As such, the system is listed for spares/repair. - Further information regarding issues faced are stated below. The lab stated it had been not used for some time but had some issues. The system units include: - Oxford Diffraction Xcalibur PX Ultra - Serial No.: XXH-127/05 - Year: 2005 - Powered on with mains light, Shutter Closed status light, inner display screen, and hand-held remote keypad all functioning - Oxford Diffraction X-ray Protection Cabinet - Serial No.: XPD-127/05 - Year: 2005 - Thermo Scientific Neslab ThermoFlex 10,000 Recirculating Chiller - Serial No.: 1111473501170217 - Powered on but shut off after 1 second with error code "PHEr" (limit fault) - Oxford Diffraction KMW200CCD CCD Detector Chiller Unit - Serial No.: CCA 73/06 - Year: 2006 - Powered on, but no further testing possible - Oxford Diffraction KMC3000C X-ray Tube Chiller - Serial No.: CAC-142/05 - Year: 2005 - Powered on, pump ran, thermostat seemed functional, but not fully tested - Oxford Diffraction Cryodrive 2.0 - Serial No.: R72-0558 - 6944 running hours - Powered on, but no further testing without gas supply - Oxford Cryosystems Cobra Controller 700 Series Cold Head Controller - Serial No.: 741174 - Powered on, displayed ambient temperature, status lights, and responsive buttons - Parker NitroFlowLab Nitrogen Generator - Model No.: 4278 - Serial No.: 4278-13NFLC0008 - Powered on, displayed a message "writing information to an SD card," and did not allow further actions - Oxford Cryosystems Standard Cobra Nitrogen Control Pump - Serial No.: CB171 - Agilent HS 602 Vacuum Pump with NW25 Oil Exhaust Filter - Model: 849-9365R001 - Serial No.: 232830 - Year: 2006 - Produced a vacuum but failed a PAT test on insulation Additional notes: - All units passed a PAT test except for the Agilent vacuum pump, which failed due to insulation issues. - The Xcalibur unit and Neslab chiller were only visually tested due to larger power plugs. Manuals included: - Oxford Instruments Object Bench Software handbook - Xcalibur Series user manual - Thermo Scientific Recirculating Chiller Operation, Installation, and Maintenance manual - Oxford Diffraction KMC3000C user manual - Oxford Cryosystems Cobra operation guide - Safety Matters cryogenic safety manual - 2 x CrysAlis Pro user manuals - Oxford Instruments Cryojet Controller UMC002 manual - Workstation 4 VMware v4.52 Virtual Machine Software and manual Accessories included: - 1 x set of keys for safety cabinet - 1 x Long Fine Focus unit (Type OD2773/00, No. 163054) - 3 x glass vacuum traps (2 litres approx.) - 2 x vacuum pump platforms - 2 x Parker wound filter cartridges (Part No.: M11R10A) - 2 x Agilent KMW3000 filter cartridges (Part No.: IJ-00-01-002) - 1 x carbon filter nitroflow mobile - 6 x data cables - 4 x Cobra stainless steel line drier units - 1 x 4-way valve purge block - 1 x box of stainless armoured hose pipe and 1/4" plastic tubing

F2 Mass Standard - knob weights, service case. Nominal value - 250 kg.

The MW-01-A mass converter is designed to be a component of an industrial load cell scale. Depending (more) on the needs, communication with the mass converter can be carried out via the following communication interfaces: RS232, RS485, Ethernet, Ethernet IP, Profibus or Profinet. The MW-01-A mass converter is compatible with indicators and PC. Operation of the MW-01-A mass converter via PC is carried out using „MW Manager” software.